Can´t get out !!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

wingren

New Member
Posts
126
After fitting a new radiator and a new hose(the triple one fromthe headertank)
I went for a cruise in the snow today , but when I came home I couldn´t open the drivers (lhd) door , works allright from outside , and the c-lock works as it should , but when I try to open from inside nothing happens , there is the "springy" resistans but it doesn´t unlock .
Ideas ?

HW
Sweden
 
doesn´t open at all , I tried to push the button down , tried to unlock with the key from outside , everything except the interior "dooropening handle" works fine , is it possible that something has frozen ? don´t think so really because it works fin from the outside but..
 
wingren said:
doesn´t open at all , I tried to push the button down , tried to unlock with the key from outside , everything except the interior "dooropening handle" works fine , is it possible that something has frozen ? don´t think so really because it works fin from the outside but..
Click to expand...
Link come off.
 
link and cable is likely , but why is there still "normal" feel when pulling the handle , is there a seperate spring ?
 
My old p38 did this from time to time of the lhs when really cold! guessing it was water freezing in the mech cos if I left it ideling with heaters on full after about an hour it opened fine
 
My old one did that too, now and then, 1 screw behind inside handle out and reattach cable with long nose pliers. No need for door card removal
 
off course the cable had snapped , so, how do I remove the door side , without breaking it ??
 
?que? it´s the front left door trim I need to take out , must be enough to just open the door and remove ,what ever I need to ,to get the trim out?
 
wingren said:
?que? it´s the front left door trim I need to take out , must be enough to just open the door and remove ,what ever I need to ,to get the trim out?
Click to expand...

Think he was referring to reattaching the cable not replacing it. Cannot remember if there is enough room to remove the door card without removing the seat. Two screws in the grab handle, one screw under the speaker cover which prises off using a small scraper ,and one screw that hold the handle backing then pull the door card off its clips. Disconnect speaker wires and you have access. Hope I haven't forgotten anything, I will soon be corrected if I have.:D
 
tomcat59alan said:
Think he was referring to reattaching the cable not replacing it. Cannot remember if there is enough room to remove the door card without removing the seat. Two screws in the grab handle, one screw under the speaker cover which prises off using a small scraper ,and one screw that hold the handle backing then pull the door card off its clips. Disconnect speaker wires and you have access. Hope I haven't forgotten anything, I will soon be corrected if I have.:D
Click to expand...

Think he said he could open door from outside, so access for door card removal is not a problem. :)
 
Druim said:
My old one did that too, now and then, 1 screw behind inside handle out and reattach cable with long nose pliers. No need for door card removal
Click to expand...

wingren said:
off course the cable had snapped , so, how do I remove the door side , without breaking it ??
Click to expand...

Did you try as I said? Of-course you did how else would you know the steel wire cable snapped before the plastic attachment:cool:
 
You must log in or register to reply here.

Similar threads

M
I WANT ANOTHER AUTOMATIC FREELANDER
Replies
5
Views
629
Rank Amatuer
Rank Amatuer
Pauldw
Disco 2 TD5 - Heater Blowing Cold
Replies
2
Views
944
Interceptorxj
Interceptorxj
Montyjohn
P38A Alternative Thermostat - V8
2
Replies
31
Views
2K
Datatek
Datatek
D
2001 D2 - Locked Out
Replies
4
Views
959
tilly2
T
T
Land Rover Discovery 1 V8i 3,9 L EFI doesn´t start
2 3
Replies
49
Views
7K
Ratae
R
Back
Top