Disco 2 Burst a bag converting to springs

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I'm not throwing money at this motor prob do the bags then the compressor will fail its been driven for nearly 80 miles on its ar$e.
+1
With steel springs you lose more than you gain. The operative phrase is "Self Levelling" which means that no matter how much you put in the back (within reason), the suspension will level itself. You'll also lose the additional off-road lift of about 2 inches with just the press of a button on the dashboard. If you have the remote controller (plip) or the David Pye modification you're also able to lower the suspension to make loading or hitching a trailer easier.

If I remember it didn't lift from the button on the dash so I have an underlying problem anyway, also I do
not have the remote to lower it for towing & I don't go off-road in it. I have 2 other landys :D
I only use it for going to work & chucking my tools & cr@p in.

Got a spare bag off a mate
Jacked it up bag off & on less than 5 mins & started the engine & compressor was running
but didn't inflate, removed the cover sprayed soapy water over the pipes no leaks (all doors closed)
turned the engine off took the key out & the compressor buzzed on & off about 5/6 times anyone had this.

Cheers ;)
 
Last edited:
Just been laying wood flooring, phew.

Had over £1k worth in the back once

Id bet your back is killing you !!

I ripped all my wooden flooring up & tiled the full cottage 200 square meters & that was heavy
the d2 was on it knees so I had to go back for adhesive lol
 
Id bet your back is killing you !!

I ripped all my wooden flooring up & tiled the full cottage 200 square meters & that was heavy
the d2 was on it knees so I had to go back for adhesive lol

Saleslad loaded, and boys unloaded.

Kitchen done, living room started, then hall to do.
 
I'm not throwing money at this motor prob do the bags then the compressor will fail its been driven for nearly 80 miles on its ar$e.


If I remember it didn't lift from the button on the dash so I have an underlying problem anyway, also I do
not have the remote to lower it for towing & I don't go off-road in it. I have 2 other landys :D
I only use it for going to work & chucking my tools & cr@p in.

Got a spare bag off a mate
Jacked it up bag off & on less than 5 mins & started the engine & compressor was running
but didn't inflate, removed the cover sprayed soapy water over the pipes no leaks (all doors closed)
turned the engine off took the key out & the compressor buzzed on & off about 5/6 times anyone had this.


Cheers ;)

kevstar,

Not uncommon, unless you disconnected the battery, and jacked the car up on the tow bracket, it is likely that the sensors now need re-calibrating, as they will be "confused". You could try closing all doors and windows, leaving ignition on or better start engine and jack back up slowly off the tow bracket. Sometimes this kicks the compressor back into sense again, otherwise sounds like they need re-setting. Find somebody near you with a Nanocom or Hawkeye to do it for you, but remember the values in Nanocom are just that "values", they are not actual heights. You must measure with a tape from the centre of the hub the the wheel arch, not liner to get it right.

It is quite usual for the compressor to run even while ignition is off as long as all doors and windows are closed. Some cars do some don't, at least you know it is working.

Tony
 
kevstar,

Not uncommon, unless you disconnected the battery, and jacked the car up on the tow bracket, it is likely that the sensors now need re-calibrating, as they will be "confused". You could try closing all doors and windows, leaving ignition on or better start engine and jack back up slowly off the tow bracket. Sometimes this kicks the compressor back into sense again, otherwise sounds like they need re-setting. Find somebody near you with a Nanocom or Hawkeye to do it for you, but remember the values in Nanocom are just that "values", they are not actual heights. You must measure with a tape from the centre of the hub the the wheel arch, not liner to get it right.

It is quite usual for the compressor to run even while ignition is off as long as all doors and windows are closed. Some cars do some don't, at least you know it is working.

Tony

Cheers Tony

The compressor is shot, I had a mate put it on the latest snap on diagnostic & re-set everything
so I have put a couple of springs on it atm (so it is usable), I only use is as a run about & for work
which is local anyway. I am looking for a nice D2 hence why I'm not spending any money on this
one, plus I have 2 projects to finish haha ;)
 
Back
Top