Bull bar question
- Thread starter adamjf
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
arienol
New Member
- Posts
- 334
- Location
- Work London - Home Norwich
If you start listing faults then your signature is going to get quite long, quite quickly 
adamjf
New Member
- Posts
- 96
If you start listing faults then your signature is going to get quite long, quite quickly
Yeah i have figured that out. Will be redoing it
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
yes you will, as they bolt to the same place as the bumper does on the chassis. i left my bumper complete thou. side note you will need to either remove or notch the plastic part that the number plate dcrews to
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
yeah the front vallance does tend to get ripped off when playing. i left mine on as she doesn't really go off road. plus i like the look of it on.
xat44
Active Member
- Posts
- 474
- Location
- biggin on the bump
so out of curiousity. is a set of bull bars strong enough to be used as a towing point if you get stuck of road?
are`nt they also supposed to be illegal, or is it just a myth?
are`nt they also supposed to be illegal, or is it just a myth?
Only illegal if bought brand new, if bought second hand then it should be ok ... but if plod got fussy you would have to prove that they were originally on the car from the factory (yes officer they were on it when I bought the Disco
)xat44
Active Member
- Posts
- 474
- Location
- biggin on the bump
ok, taOnly illegal if bought brand new, if bought second hand then it should be ok ... but if plod got fussy you would have to prove that they were originally on the car from the factory (yes officer they were on it when I bought the Disco
Bromsgrove Defender
Well-Known Member
- Posts
- 5,759
- Location
- Out to lunch
NOOOOOO
do NOT use as a towing point not actually illegal to buy. But illegal to sell new........I think
bobbler
New Member
- Posts
- 2,773
- Location
- County Durham
possibly depends on the type of bar but no modifications were required when i fitted mine, just rested nicely against the number plate surround.
:5biagree:If it's an official LR product then it will fit without adjustment's, some after market ones sit closer to the bumper though and do require a bit of plastic trimming.
alex8882
Well-Known Member
- Posts
- 1,377
- Location
- lytham,st.annes
mine did. had to remove th3 plastic trim behind the reg plate. Mine also have a towing point at the bottom which are part of the bracket
bobbler
New Member
- Posts
- 2,773
- Location
- County Durham
towing points on mine too, one on each side so took the original towing eye off when i fitted it ok for a short tow but not enough for a recovery point
thought i was going to have to remove the valance but a little pressure and it fit straight through the holes.
ok for a short tow but not enough for a recovery point thought i was going to have to remove the valance but a little pressure and it fit straight through the holes.
