Brake lights issue

M

martin41076

Active Member

Posts

65

• Oct 13, 2023

• #1

Had the dreaded two amigos on the dash - TDC/HDC.
At this stage brake lights worked as normal.
Took out brake light switch - which practically disintegrated in my hand and replaced with new.
Reconnected all wires as before.
Warning lights now gone but brake lights aren't working.
Need to get sorted so I can book MOT.

 

M

martin41076

Active Member

Posts

65

• Oct 13, 2023

• #2

martin41076 said:

Had the dreaded two amigos on the dash - TDC/HDC.
At this stage brake lights worked as normal.
Took out brake light switch - which practically disintegrated in my hand and replaced with new.
Reconnected all wires as before.
Warning lights now gone but brake lights aren't working.
Need to get sorted so I can book MOT.

Click to expand...

Should also mention that fuses are OK.

 

andyfreelandy

Well-Known Member

Posts

5,586

Location

Devon

• Oct 13, 2023

• #3

Did you adjust it? Switch is normally made and breaks with pedal released. Slide down to pedal with hand pressing pedal down and a ratchet self adjusts when you release pedal.

 

M

martin41076

Active Member

Posts

65

• Oct 13, 2023

• #4

Yes, done that and checked it. Warning lights disappeared after fitment.

 

andyfreelandy

Well-Known Member

Posts

5,586

Location

Devon

• Oct 13, 2023

• #5

Leave wired up, twist and remove switch lights should light. Otherwise you are into checking voltage and tracing circuit. Could it be all bulbs blown ?? Possible.

 

M

martin41076

Active Member

Posts

65

• Oct 13, 2023

• #6

andyfreelandy said:

Leave wired up, twist and remove switch lights should light. Otherwise you are into checking voltage and tracing circuit. Could it be all bulbs blown ?? Possible.

Click to expand...

All sorted.
Took switch out, pulled out plunger, put back in & reset - brake lights on permanently, switch off when I press brake pedal!
Took out, reset plunger again, all working as normal