Brake adjustment

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Muddy110

Member
Posts
13
Location
Kent
hi all I wondered if anyone knew how to adjust the rod on the brake master cylinder on a series 2. Recently put a new master on and I must have adjusted it wrong as when I drive all four brake start to stick once I press the pedal a few times so fluid isn’t being pushed back in to brake Reservoir any help appreciated regards scott
 
With the pedal held up by the spring there should be a little slack between the rod and the end of master cylinder piston 1.6mm given in a book I have.
Adjust nuts to give this slack.
 
Back
Top