Bolt size Turbo Core
- Thread starter Mingus
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
I'm sure i recall them being M8, I just cut bolts down to size. If you've still got it apart check the thread on the manifold
Flossie
Well-Known Member
- Posts
- 10,691
- Location
- Shropshire
On a 200tdi disco, one bolt at least was a bugger to access, open ended spanner only? It's been 16yrs since I removed mine but I also think they were M8, nowt special, I replaced with stainless bolts.
ta, on a 300 tdi you need a 1/2 inch spanner rather than a 13mm to remove which is a bit weird. Good old landrover with their mix of metric and imperial although i guess its Garrets fault.
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Certainly didn't find that with mine although I did have to grind down one side of my spanner to fit it into the gap. I expected them to be a nightmare to undo but they weren't too bad
- Posts
- 11,020
- Location
- North of the Wall
Pretty sure mine was 1/2 inch too. 300 Tdi
