"Bloody P38 Half-Cars"

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

"Gaddaffi"

New Member
Posts
6
Location
Inland Australia
No sooner do I give it a bit of praise because it finally has got it's **** together and IS working properly, but I take it for a car wash, cop an extra-forceful under-car sprayer and the bloody thing has since been handing me SELECT NEUTRAL and blinking all its "widdle (green and red) wights" @ me and has selectively deleted changing range, just stays in "high".

Shift change motor floooded? Full of water from the sprayer?

I've been under it and done all the push-in connectors, just haven't drained the motor as yet. Would this be the likely fix, or will I find the range selection motor is cactus and need to fit another one?

Gaddaffi
 
[quote="Gaddaffi";783649]No sooner do I give it a bit of praise because it finally has got it's **** together and IS working properly, but I take it for a car wash, cop an extra-forceful under-car sprayer and the bloody thing has since been handing me SELECT NEUTRAL and blinking all its "widdle (green and red) wights" @ me and has selectively deleted changing range, just stays in "high".

Shift change motor floooded? Full of water from the sprayer?

I've been under it and done all the push-in connectors, just haven't drained the motor as yet. Would this be the likely fix, or will I find the range selection motor is cactus and need to fit another one?

Gaddaffi[/quote]

Lovely cars but not really a true 4 X 4, bits fall off if you go over lumps of rock and they are scared of water:eek::eek::eek:
 
Thease bloody Range Rovers are ok if you dont get them dirty or wet, on the program Top Gear they lost a Toyota Hilux in the sea, when the tide went out it started and drove to its next challenge
Yea check the motorand the earth connections around the vehicle as a bad earth will ammuse you for hours what they can do.
I know you should not have to do this with a off roader but every 3 or 4 months i get under my P38 and spray all the connections ect with waterproof grease , never had any problems so far, "why did i just say that"
 
"Why did I Just Say That?"
EXACTLY! And somewhere within the next wee period of hours or weeks or days, when you are where there is NIX U can do about it a.t.t. it's gunna let you know why you should NOT have said that.
But you KNOW that.You obviously have been the miles.
Required replacements on mine thus far:
Engine (liner leakage)
W/Pump on replacement donk (Took chance pump WOULD be ok. Should have known better, This IS a Range Rover) And it picked a late am Sat slot to produce this, prior to 1,00O km trip home departure, when ALL outlets that might've had a pump were closed. Three days more to get home........
T/case (dealer only fixed front output U-J, deliberately did not replace the output/support bearing. It is an external load, circlip retained, so it's supposed to be routine replacement. REMEMBER THIS, as what it supports is the torque splitter, and you DO NOT want to have to pay for THAT replacement.)(Dealer is no longer dealing).
Front hubs
Front rotors (wave pattern from above hubs laxity)
Exhaust, and re-do heat popped air lines to air tank and R rear airbag.
Shock(er)s. Bilsteins are! 100,000 km and stuffed. Now Koni Heavy Tracks.
Re-weld driver's seat base (twice) - and it shows signs where it had been done before i got it also. I'm only 96kg. Get's int'restin' when it lets go.
Rear brake hoses (Hacksawed @ centre junction by well-meaning dissident and pulled from support clips so it would look (hopefully) like maintenance neglect vibration fracture when the intended mountain country and, naturally, "excessive speed" wreck was sussed).
Well I'm here writing this, aren't I. Needless to say, did not occur. And MAY not be so likely in the future as recurrence/s, either.
Engine ignition sensor
Fuse block
Coil packs
H/T leads
Descending heater hose to thermostat replaced with plain hose where the factory "kinked" one rubbed on (and through) on the serpentine belt. Now that is witless engineering if I ever saw it.
Tailgate lock now "modified" to internal and "Armstrong" operation when it does not do its widdle electwonic twiddlwings on push of button.
Have had to re-make upper tailgate lock three times.........
Air-con vents block and flood the passenger side floor.
Air-con compressor replacement and re-gassing. It is giving me "THE BOOK" a.c.t. also, but while it IS working it can stay such.
Or should I say HALF-working, Drivers side front only has a/con or ambient, but zilch heating function. Real good for bird 'flu and the winter.
Then there's the EAS! Don't even bloody tALK to me about this piece of "under-achieving" tripe! Kerrist! On RR EAS back @ the first Easter there is NO way "HE" would have ever risen again, let alone "from the dead".
AND IT CONTINUES!
Vehicle is an outback Oz Qld vet truck, and the things it has to do you'd have Patrol and 'Cruiser wagons on their head and in the gullies. And, funnily enough, I LIKE the thing. Which may be helped by that it is backed up by RRC's, a '75 in throes of refurbishment @ current, and an '86 4-door whose auto is feeling a bit "tired" currently, having borne the brunt of service while it's nose-up-in-the-air big brother got itself sorted [EAS] these last near-twelve months or so.
 
So we got out the spanners today, having necessarily first abided by the mandatory rule of anything mechanical - like Granpa said, "if it's got tits wheels or tracks on it son it's goin' give you trouble somewhere's down the line" - hugely politically un-correct but accurate in my (retarded and less than complete 60+years) experience - this being "Where is that other shift change motor" - stripped it off (of) the stuffed T/Case, and fitted that, plus went over the whole damn underside while there.
Result: Problem APPEARS to be sorted. All Quiet On The P38a Half-Car Front. [For NOW!]

Stripping of the removed motor and bevel drive unit elicits it is dry as toast inside. Possibility is thereby a stuck brush on the motor, or something mechanical wrt the power leads/connectors/internal switching. It will be going in to someone I trust for a check-out when I get the opportunity.

"Gaddaffi"
 
Hi there,
Sounds exactly like mine, I had this problem kept saying select neutral and was in neutral but the way i got it to change from high to low ever since is when it says select neutral put it in first gear with clutch in and handbrake on then press the button, cant guarantee it will work for you but does for me everytime. All i can say is try it mate.
Paul
 
iam a p38 owner and proud of it . i think it all boils down to either u have a good un or in most cases not .. i was one of the lucky ones :):):mooning:
 
Thease bloody Range Rovers are ok if you dont get them dirty or wet, on the program Top Gear they lost a Toyota Hilux in the sea, when the tide went out it started and drove to its next challenge
Yea check the motorand the earth connections around the vehicle as a bad earth will ammuse you for hours what they can do.
I know you should not have to do this with a off roader but every 3 or 4 months i get under my P38 and spray all the connections ect with waterproof grease , never had any problems so far, "why did i just say that"


Yeah and you believe that. After about two days draining oil and filling and draining diesel tank and refilling. Probably replacing alternator and starter, battery and every switch on it.
 
Back
Top