- Posts
- 4,609
Should I use a sealant between the bellhousing and the gearbox ?
Bellhousing to gearbox sealant/gasket
- Thread starter miktdish
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,082
- Location
- west wales coast
Usual to have gasket.
- Posts
- 4,609
Can't seem to find one ?
tottot
Well-Known Member
- Posts
- 8,082
- Location
- west wales coast
Bell housing to clutch housing no. Just replaced my bellhousing onto gear box and there was a paper gasket for it in the gasket set.
- Posts
- 4,609
Haven't taken it apart yet (the old one is still on the car) but I remember seeing some form of 'squeezed out', hardened, sealant at the faces ...
Not to the engine no .. although I did use a thinned Blue Hylomar on the LT230 interface.
- Posts
- 4,609
Got the GBox out today ... here's a pic of the bell interface.
Deffo got some form of sealant.
Deffo got some form of sealant.
- Posts
- 4,609
It was silicone ...
Similar threads
