Back Door Window!

"TAIL DOOR GLASS OPENS AUTOMATICALLY IMMEDIATELY AFTER CLOSING

Bulletin Number - 0104

Issue - 1

Date - 28.08.2002

Model - Freelander

Affected Range - All derivatives

Re-Issue Information

Problem -

TAIL DOOR GLASS OPENS AUTOMATICALLY IMMEDIATELY AFTER CLOSING

Cause

Tail door glass calibration incorrectly set within the Central Control Unit (CCU).

Action

Where a complaint of the above is confirmed, follow the calibration procedure below to reset the tail door glass.

Calibration procedure

1. Disconnect the battery earth lead. Refer to Workshop Manual, General Information, Electrical Precautions, Battery disconnection.

NOTE: Allow ten seconds to elapse between disconnection and connection to erase the stored calibration value.

2. Connect the battery earth lead.

NOTE: The tail door glass will drop approximately 2 seconds after the battery has been connected.

3. Start engine.

4. Ensure that all electrical loads, i.e. lights, heater etc. are turned off.

5. Increase the engine speed to 1500 rev/min for 10 seconds, after 10 seconds and whilst maintaining 1500 rev/min, carry out the following operations:

Close the tail door glass to calibrate the CCU.

Fully open the tail door glass.

Fully close the tail door glass.

If the tail door glass remains closed the calibration procedure is complete, refer to step 6.

If the tail door glass opens then repeat the calibration procedure from step 1.

6. Allow engine to idle then switch off engine."

Click to expand...