Anyone tried DynaBeads for wheel Balance

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

stopover

Active Member
Always had a bit of a problem with tyre balancing. At 80-90+ mph I always get a vibration from the front regardless of having all tyres balanced before very long trips - eg Europe or to Scotland so have invested in some DynaBeads but haven't been on a long trip yet to see if they work as claimed! Also I don't have a fast (yes) but not long enough road here in the Isle of Man. I went this route as DynaBeads cured my bad wheel wobble on a pre-war (1932) car.
Check them out at Buy Dyna Beads Dynamic Tyre Balancers now!

Car is a 4.6 2000 Holland & Holland with 147,000 happy miles. Normally pulls like a trail but I stuck some injector cleaner in on last trip (What a fool!) and now have some blocked injectors. On the Thor engine there is no fuel filter on the chassis just the foil one on the pump. Stupid!!!
 
Last edited:
Lots of this was use in the USA at one time. Hard rubber ring that fitted inside the wheel trim with lead shot in it. This is just a version of that. It supposedly works but that was long before proper wheel balances were available. Can't say i would think of using them though.
 
Lots of this was use in the USA at one time. Hard rubber ring that fitted inside the wheel trim with lead shot in it. This is just a version of that. It supposedly works but that was long before proper wheel balances were available. Can't say i would think of using them though.

Used on semi trucks here as they don't do machine balance. cars, suv, light trucks are machine balance since the 50;s.

Not good for your cars you drive far enough to get tyres up to operating temp to get rid of flat spot from sitting over night
 
Back
Top