Anyone found any mud flaps that aren't £60?
- Thread starter james6546
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
greyhair
Well-Known Member
- Posts
- 1,303
- Location
- IN MY SHED
make some mate
Only joking I have no idea, been looking on flea bay
Only joking I have no idea, been looking on flea bay
Ha, I have considered it, wonder what they would look like made out of some old floor mats! Might take some measurements of the old ones.
For genuine flaps they are £60 for back and £50 on front even on ebay.
The britpart ones are cheaper, but say BRITPART across them in yellow!
I am thinking maybe something like these
JJC Rally/Motorsport Mud Flap (Mudflap) Material 50cm x 30cm x 4mm MSA Spec | eBay
With some genuine brackets. What you reckon?
JJC Rally/Motorsport Mud Flap (Mudflap) Material 50cm x 30cm x 4mm MSA Spec | eBay
With some genuine brackets. What you reckon?
vilguy
Do'er of stuff and the like
- Posts
- 9,915
- Location
- Dumfrieshire
ive got a spare pair of muddy flaps in the garage.spanking new in their wrapping
Front or rear?
If they are rear do they have a cutout for the exhaust?
If so do you want to sell them to me?! Or were you just saying?!
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Aw geez them!!
vilguy
Do'er of stuff and the like
- Posts
- 9,915
- Location
- Dumfrieshire
ill have a look when i get in tonight. I have no idea to be honest. I have had them for about 3 years!
greyhair
Well-Known Member
- Posts
- 1,303
- Location
- IN MY SHED
Alpha Wolf
New Member
- Posts
- 75
- Location
- NW England
I have just ordered some off this place
Land Rover Defender Mudflaps | Paddock
I haven't fitted them yet so I don't know what there are like and the rear left doesn't have an exhaust cut out (but then again the one that's on hasn't either)...
Land Rover Defender Mudflaps | Paddock
I haven't fitted them yet so I don't know what there are like and the rear left doesn't have an exhaust cut out (but then again the one that's on hasn't either)...
D90mitch
Well-Known Member
- Posts
- 2,419
I'm looking for some new ones too. quite liked the snap on/off ones that also stop all the dirt going in the cross member. Expensive though. Not sure why.
SmileySteve
Well-Known Member
- Posts
- 1,423
- Location
- Dumfrieshire
Got same ones, fronts been on for over a year and fine, but need to make or buy more brackets for the rears, seem fine for the money
Ok, thanks. I might end up getting some of them I think.
Knowing my luck I will buy some and then they will say Britpart, why would you want to advertise that?!
Me too, think I am going to try to make some of my own to protect the outrigger and rear crossmember.
Ta, will get some of them
vilguy
Do'er of stuff and the like
- Posts
- 9,915
- Location
- Dumfrieshire
ah they are britpart 110 rears
Easy way to make them easy to remove, stick m6 stainless bolts cross member side pointing down, then fit and tighten a nylock nut, slide mudflap bracket over bolts and then fit std plain m6 nuts, voila cheap as chips and minutes to remove for trialling etc.
