Another Bug Mistake, Please Help

Al2O3 said:

Just get hold of it with your fingers, they pull out easily. On the other end is another set of splines that slide back and forth.

Click to expand...

Will have a go tomorrow and see how I get on, I did try that when I was there but it seemed pretty solid, then again I had grease all over my fingers.

You might have to take the drive member off then pull it out, replace the drive member carefully.

nobber said:

You might have to take the drive member off then pull it out, replace the drive member carefully.

Click to expand...

There both off already, Just need to get a grip on the shaft to pull out a little.

Yeah, stop being a big girl and man handle it! Try some grips or something.

nobber said:

Yeah, stop being a big girl and man handle it! Try some grips or something.

Click to expand...

Will do tomorrow, didn't really know they would pull out till I started this thread, thought Id done something wrong in putting back together, Itching to go up now and do it, but to cold out there now and fire will be out now anyway.

Well James was right Again his exact words were pull half shafts out fit flange then circlip then push home, that's all I had to do. Think I just Panic to much sometimes.
Although I did forget to put Locktight on the bolts, will have to loosen them again and get some on.
Thanks Everyone
Just looked at photo again and looks like I've put the drum screw in wrong hole too