Alternative to seal between windscreen and bulkhead?

I have just had the O/S bulkhead welded but a bit of the seal between the windscreen frame and the bulkhead has perished in the rust and is no longer there! Only about a 4 inch section, to be fair...

Shall I just squeeze in some silicone sealant? Or do I really have to get a whole new seal and lever up the windscreen frame, undo the roof, etc etc etc? If I need to do it properly, any top tips or hints?

All advice gratefully received!

Cheers,

Vulch

I also need a blank panel for the nearside hole in the wing top - opposite side to the air intake (200TDi) - but don't know what its called@!!$£@! 20 minutes of searching on various sales sites and no joy... Does anyone know what it's called?

Cheers,

Vulch

Vulch said:

I also need a blank panel for the nearside hole in the wing top - opposite side to the air intake (200TDi) - but don't know what its called@!!$£@! 20 minutes of searching on various sales sites and no joy... Does anyone know what it's called?

Cheers,

Vulch

Click to expand...

Maybe like this?

genuine Land Rover Defender air intake black blanking vent set wing top 90/110 | eBay

Silkiflex 291 - that's what you need

Thanks guys! Right blanking panel and the sealant is Sikaflex 291 - also known as (or very similar to) Sikaflex EBT - available from Mr T Perkins. Picking a tube up later on. From the sound of it, this stuff should live in every man's man draw. Sticks everything to everything. Seals everything.

Cheers,

Vulch