Now then! I plugged in the EAS unlock suite to the car in an attempt to depressurise the system, instead I ended up with a " slow 35 mph max" message! Not sure how, maybe didn't exit the software properly. It is there when I put the ignition on now with the computer NOT connected. Anyway at the time I didn't manage to sync with the car. A short time after I plugged back in and found the correct comm's port (FF 1 sent and FF returned with green good idle) and let the air out of tank. Both pump and valve block now refurb and back in RR. How do I get rid of the message? My limit understanding is the RR pump will not run unless the message goes.I synced with the RR and read the messages then cleared them, no messages showing now and pump ran. Tank full of air and showing at normal level on dash suspension switch BUT drivers side seems higher than passengers side! If I can get rid of message the possible I can see what's going on with the height on one side. Didn't have any trouble before with one side lifting higher but it was taking about 15 mins to get the suspension switch to stop flashing so this was the only reason for rebuilding block and pump.
So has anyone got any good news for me? On the EAS unlock suite what is the last screen for? I see it has 20mph, 35mph boxes to click and wondered if this is used for the problem I have!!
Regards Clive
