P38A adjusting front suspension hight

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tarphenry

tarphenry

Well-Known Member
Posts
1,540
Location
bury lancs
Hi all, just measured my hights and the front is 25mm higher then recommended. I have a nanocom and am able to access the sceen which will enable me to enter a lower value but cant seem to clear the existing value(presently124) to enter a lower value. Can anyone explain where I going wrong. Thanks
 
You have to use the cursor & select buttons on the screen.

There is one caveat I found, which is you cannot save values lower than the next height setting down. Not sure whether this is Nano or EAS ECU preventing it, but when I did mine, I had to lower all the Highway values first, and then lower the Standard values. Both modes were about 1" too high.
 
settings screen .I can touch the white value and the keyboard screen comes up with the 124 on but i cannot delete it to alter the value
 
There's a Delete or Backspace button somewhere in the on-screen keyboard. I will check later today when I'm out in the car.
 
Follow this don't change settings by more than two beats at a time. Make sure you are on correct screen when you do it. You must be on standard screen to reset standard settings.


 
Last edited:
You must log in or register to reply here.

Similar threads

M
Air suspension problems
2 3
Replies
59
Views
6K
Rubberknees
Rubberknees
M
Air suspension problems
Replies
1
Views
733
Datatek
Datatek
Freddie17
Freelander 2 (LR2) Front suspension clunk and judder (SOLVED)
2
Replies
36
Views
3K
Freddie17
Freddie17
Z
Air suspension fault c1130. L322 TDV8 09 plate
Replies
4
Views
1K
zeff737
Z
rover75lover
l 322 air suspension problems
Replies
4
Views
2K
Datatek
Datatek
Back
Top