P38A Adjustable panhard rod?

300bhp/ton said:

Does anyone sell one for the p38? Or maybe one from another vehicle (D2/Defender) that would bolt up easily?

Click to expand...

Grrrrrr said:

You've gone up higher than the EAS would?

Click to expand...

300bhp/ton said:

Higher than the off road mode I think or maybe somewhat equal to it. Not really an issue, but you can visually see the axle is moved over to one side.

Found some adjustable ones in the USA but silly money and seem to use a heim joint instead of bushes. So isn't what I'd want any way.

I think modding the factory items should be pretty easy, just need to find the bits I'd need. I found this as an old post on another forum:

If I could find a supply of the rods and caps it would be fairly easy to achieve.

Click to expand...

Joebur123 said:

Hi sorry to ressurect an old thread but how did you get around this problem did you find a set of adjustables or did you modify the originals? Any help would be much appreciated

Click to expand...

Joebur123 said:

Hi sorry to ressurect an old thread but how did you get around this problem did you find a set of adjustables or did you modify the originals? Any help would be much appreciated

Click to expand...

Mark Piercy said:

Maybe cut add and weld

Click to expand...

Mark Piercy said:

OH you are deep in sticky stuff on your avatar

Click to expand...

Joebur123 said:

Yes, I was thinking along the lines of welding a nut on and fitting a threaded hiem joint to one end

Click to expand...

Mark Piercy said:

That's not a bad idea tbh

Click to expand...

Joebur123 said:

Need to get underneath over the weekend and take some measurements but from what I've seen should only cost about £50 to do front and rears so will post back with how it goes

Click to expand...

Mark Piercy said:

With pictures please

Click to expand...