ACE to a Non ACE Disco2

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
In theory yes,

But you would need LOTS of bits and money, shortlist is sort off :-

All pipe runs to and from Valve Block (not cheap)
Valve Block assy
Accelerometers x2
Pump assy
New reservoir
New Aux Belt
Front and rear Anti roll bars / actuators
Roll bar bushings / fittings
ACE Ecu
Fluid
BCU re-configuring.
Testbook or similar to Bleed the system
 
Urban Panzer said:
In theory yes,

But you would need LOTS of bits and money, shortlist is sort off :-

All pipe runs to and from Valve Block (not cheap)
Valve Block assy
Accelerometers x2
Pump assy
New reservoir
New Aux Belt
Front and rear Anti roll bars / actuators
Roll bar bushings / fittings
ACE Ecu
Fluid
BCU re-configuring.
Testbook or similar to Bleed the system
Click to expand...

sounds like a plan does nayone have a definitive list of parts needed.
 
Tbh, you would be nuts to do it, or have more money than sense.

With new parts your looking at £1200 +

With using second hand parts, then you could open a can of worms for yourself.
 
Dont ge me wrong the ACE system is superb, and worth having, but worth retro fitting ? mmm dunno tbh ref cost etc involved

For what it would cost in new parts and £1200 was a "rough figure", it would be cheaper / easier to probably sell your disco and buy one with ACE.
 
i like a challenge, i know a guy breaing a disco with ace so can probably get parts pretty cheap, just wondering if it was possible without changing thinks like axels and majour components.
 
You are insane. for the problems it gives when i goes wrong its rearly not worth it. most people take it off not put it on lol.
 
martinhollings said:
people remove the ace because the parts are so expensive the list that up gave is about all you need good luck but you mad just the sort of thing i would do
Click to expand...

Seeing my scape dealer mate at the weekend he is breaking one with ace so will go and remove all the parts I need and have a go fitting it will also get the bcu from the scaled one
 
Martins right, so imo it's easier to program YOUR BCU to say ACE is fitted, than programming new keys and codes to the other one, either way its a diagnostic tool session on the horizon.
 
You must log in or register to reply here.

Similar threads

G
Anti Roll Bar disconnect
Replies
16
Views
2K
Gingerbread
G
T
Ace problem !!
Replies
3
Views
640
sierrafery
sierrafery
mad85
Disco 2 Another strange ACE issue
Replies
12
Views
1K
mad85
mad85
J
ACE problem help :)
Replies
0
Views
250
Jacek discovery 2
J
MAF Diver
Disco 2 Is my ACE leaking fluid at the actuator arm? New bushing?
Replies
9
Views
1K
MJI
MJI
Back
Top