P38A 'ABS pump pressure sensor fault'

I've got the cruise working again. I'd pushed the plunger in! Didn't know what I'd done. Went out, took switch out, pulled plunger, clickety-click, 'Aah!' Put it back. Bingo. Brake lights not stuck on anymore.

What about the switch you've ordered?

JeremyAldermartenQC said:

How do I get to the Tech. section?

Click to expand...

Top of the main Range Rover page, above the new post button!

Grrrrrr said:

Have you downloaded and installed RAVE from the Technical Section. It has everything in it.

Pressure switches can be had cheaper from another car but I cannot remember which one.

When the bulbs on my dash were acting up I needed diag to clear the fault before they would go out.

Click to expand...

Was it not a saad pressure switch

brianp38dse said:

Was it not a saab pressure switch

Click to expand...

Fixed it for you

brianp38dse said:

Was it not a saad pressure switch

Click to expand...

Think so but cannot remember the year or model. Might have been on RR.net.

Fortunately the switch I've ordered, Mark Piercy, was only £8.50 from:

https://www.ebay.co.uk/itm/xbk10017...e=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649

Which is strange because the same seller has the same switch listed at £14.95. When I've checked to see if resetting the existing switch has done anything for the ABS, I can always try the new one. If that doesn't make any difference, I'll have a spare. Thanks for the link to the Rave manual. Yes, it was a Saab. I'm told it was the post-classic GM Saab 900.

I've looked in the Tech section, but the dropbox for the Rave manual doesn't work any more.