90/110 Warning Lights Module AMR2628

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

cappers

Well-Known Member
Posts
2,224
Location
my head
Tidying up the dash wiring I took the instrument binnacle off and noticed that the warning lights module has twin tab connectors, one in each corner (circled in red in the pic). They are not connected to anything, the only circuitry to the module is the two push on wire holders in the centre .
amr2628-warning-lights-module-land-rover-defender-_57-jpg.257158

Should these tabs be attached to anything? I don't recall ever seeing connected to them on other Landys.
Cheers in advance.
 
@v8250
Was reading your thread thinking about LEDs but my dash and instrument bulbs are ok for me. I'll change them to LEDs and things will likely go wrong o_O

Glow Plug warning light.......on a V8.......:eek: No, just me downloading an image from the web :rolleyes:

This is my AMR268:
Untitled.png

The top left twin blade terminal is in front of the HRW symbol so perhaps there should be a feed to it? Can't find any spare connectors there. I'll have a look tomorrow as the 3 switch panel housing the HRW switch is also out for inspection (finding links to wire the alarm/CDL to the hazards and dome light).

As the dash is out I added a rev counter that has been sitting in my box of bits since 2018 :rolleyes: Moved the fuel gauge to where the voltmeter was. Not sure where to put the voltmeter. I have a USB-digital voltmeter in place of the cigar lighter but would still like the analogue gauge.
IMG_2193.JPG
 
I've found somewhere to put the voltmeter now I've replaced it with the rev counter in the dash.
Digital voltmeter above fuse box, analogue below!
IMG_2194.JPG

What do you think? The hole, vacant since the conversion to auto, has been bugging me. It fits and I can route the ign switched + and earth and the light feed easily enough. It's waterproof sitting in the former diff lock rubber boot.
 
Back
Top