300tdi speedo cable

Morning

apart from at the gearbox, bulkhead and speedo is there anywhere else the speedo cable is fixed - e.g. to keep it following a particular path etc.....

Just trying to work out if I can do the job by just removing plate under cubby, or if I need to go somewhere where I can get underneath the defender to undo cable clips etc.


thanks

Does your cable not run from rear of speedometer, through bulkhead, down side of gearbox tunnel to tail of gearbox and then into the gearbox? That's the normal route. There should be no need to lift cubby box plate.

The fixing points should be through P-clips to gearbox tunnel near bellhousing, on side chassis or gearbox and then at tail of gearbox before entry into speedo drive. I've replaced all of mine with st/st rubber sleeved jobbies and st/st ntus & bolts :. no rusty fasteners.

See here https://www.lrworkshop.com/diagrams...ctrics/instruments-clock/instruments_52863#21

Thanks. That’s the info I was after.

I have replaced mine via the centre panel in the seat box.

Rougharse Racing said:

I have replaced mine via the centre panel in the seat box.

Click to expand...

how did you deal with the various fixings along the cable length?

Iirc they run down the left side of the gearbox, where they come out of the bulkhead they run past the back of the cyl head.

Landy_Ben said:

how did you deal with the various fixings along the cable length?

Click to expand...

From memory there was only one fixing on the rear of the transfer box, possibly a further one in the engine bay.