200TDi Using 19J PAS Pump?
- Thread starter Mseries3
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Langers
Well-Known Member
- Posts
- 3,162
- Location
- Kent or Shropshire
Don't think it can be done without modifying the pulley on the 19j one.
Best bet would just be to pick a 200 Tdi pump off eBay, which is what I did - got a used one for £15 which has worked perfectly ever since
Best bet would just be to pick a 200 Tdi pump off eBay, which is what I did - got a used one for £15 which has worked perfectly ever since
- Posts
- 6,406
- Location
- North Perthshire
I think I read somewhere that a military style double pulley can be used on the 19j pump..but can't remember where I saw it. Otherwise - as Langers said...get a second-hand one.
Beast o Bodmin
Banned
- Posts
- 17,157
Can't find any 200TDi Disco PAS pumps on ebay
i got a pump in shed.ill check it out tomoz when its light.
Langers
Well-Known Member
- Posts
- 3,162
- Location
- Kent or Shropshire
Can't find any 200TDi Disco PAS pumps on ebay
Damn, when I bought mine the bloke had two for sale for £15 each... knew I should have bought both!
Did yer 110 have PAS before? If so you can re-use the pipes but get a company like Pirtek to change the ends for you.
The best option though is to get the original pipes from the Disco and use them - they can be used as is (though they will stick out a bit from the crossmember as they are a wee bit short) so again you can get them extended by Pirtek if you want.
instantsquid
New Member
- Posts
- 1,362
- Location
- Tadley, Hants
Or join the Disco ones to the 'fender ones using compression joints - then you can make the pipes fit like they were meant to.
Langers
Well-Known Member
- Posts
- 3,162
- Location
- Kent or Shropshire
Ahaa, yeah that would be the best option... solving the fitting and the length issues. Spot on!
I have email my local Landy place (Good bloke with lots of Discos that he is breaking!) to see if he has a PAS pump with the high pressure pipe (Low pressure pipe is straight swap i think?).
What type of compression joint is it? (Can you give me a link to one? I would not have a fekking clue what to buy!)
Cheers
instantsquid
New Member
- Posts
- 1,362
- Location
- Tadley, Hants
I can't remember what size the compression joints are - I took the pipes into a local hydraulics place and they sorted me out with them. Charged me a couple of quid each.
