200 head gasket...

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jmattley

jmattley

New Member
Posts
622
Location
Ibstock, Leicestershire
I think my head gasket is on it's way out on my 200, so I'll be changing it sooner rather than later. I've never done a head gasket before, so how big a job is it and how long does it take? Roughly of course.
I have the haynes though.
 
If you have a decent mechanical knowledge it is easy check out my pictures it took roughly a day on my drive way and cost £18 for a new gasket. The gaskets have to be the right one I think there is three sizes take your old gasket when you get the new one to make sure you get the correct one. If you can use a genuine LR manual it goes into much more detail than haynes use bungy straps to hold the exhaust manifold up you don't need to completely remove exhaust from manifold and put all push rods through a piece of card board in the order they come out don't rush and youll be fine. If youre not sure of owt let us know.:)
 
Reeto, will do, cheers mate! I'm not sure if it's the head or the P gasket though as I can see where the water has come out a bit, but not sure where it's come from. I'll find out next time I have a long run i suppose. Where does one get a proper LR manual from then?
 
jmattley said:
Reeto, will do, cheers mate! I'm not sure if it's the head or the P gasket though as I can see where the water has come out a bit, but not sure where it's come from. I'll find out next time I have a long run i suppose. Where does one get a proper LR manual from then?
Click to expand...
Normally when a 200tdi head gasket goes it blows at the back ( between the block and bulkhead ) it sounds a bit like a steam engine and is caused by a build up of carbon you can actually feel it if you place your hand of the back of the block Its happened to me on two seperate Discos both around the 130k mark you should be able to get manual off flea bay for around £25 if the water is coming from front its probably water pump which is straight forward job around two hours :) hope this helps
 
You must log in or register to reply here.

Similar threads

Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
755
Padda.116
Padda.116
G
Which head Gasket to buy
Replies
11
Views
661
NPG
NPG
T
injector screw broke
Replies
0
Views
337
toto25
T
A
P38A Head Gasket Kit & ARP Bolts ?
2
Replies
23
Views
1K
enjoi
enjoi
T
screw of injector in motor td4
Replies
1
Views
332
hd3
hd3
Back
Top