yella
New Member
- Posts
- 15,991
does anyone know what size spanner you need to remove the viscous fan on a 2.5TD
2.5td
- Thread starter yella
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
timberjock
Active Member
- Posts
- 366
32mm and its a funny shaped viscous removing spanner yur need
yella
New Member
- Posts
- 15,991
aye ive got a 30mm one and a 27mm one, but i dint know what size it were, ill get one, cheers jock 
dunt it have a hole in the pulley for undoing it ?
like this shows
Replacing a water pump. - LR4x4 - The Land Rover Forum
like this shows
Replacing a water pump. - LR4x4 - The Land Rover Forum
yella
New Member
- Posts
- 15,991
aye but its the spanner i need, yer spanner
Oddie
AntiSeptic Sandal Wearer
- Posts
- 26,178
- Location
- In a puddle in Kernow
yella
New Member
- Posts
- 15,991
aye but theres a few on ebay fer 3 quid
Oddie
AntiSeptic Sandal Wearer
- Posts
- 26,178
- Location
- In a puddle in Kernow
depends if yer need it tomorrow.
yella
New Member
- Posts
- 15,991
aye but i dunt
GRUNT
Well-Known Member
- Posts
- 8,911
- Location
- On the lake Geneva shoreline.
Yer don't necessarily need the bent spanner you can get it of with a 1/4" drive rat**** an socket, think the socket is 10mm. This obviously only gets the fan off the viscous cuppling though.
yella
New Member
- Posts
- 15,991
aye, i went down that route with the disco, but im gunna tek the lot off
