2 1/4 diesel

Terry.Lane · Dec 22, 2016

Hi all. My engine is a little knackered...I'm looking for a very good standard engine, west midlands or close... I could rebuild mine, but a standard exchange would be great... Anything? Anyone? Cheers Terry.

Land Raver · Dec 22, 2016

What's up with your engine?

It would be a gamble to buy an unknown 2.25d. I'm wary that many claim they've been rebuilt but you don't know how much or how well it's been done. To avoid a gamble, I think there are 3 options:

1. Rebuild yourself, assuming you're comfortable doing this.
2. Pay a known reputable engine builder / garage to do it for you
3. Dig deep and buy a reconditioned engine from Turner Engineering

Terry.Lane · Dec 22, 2016

It was really smoky, I took the head off as it was suggested that the head gasket had gone. I sat the valves, changed valve stem seals, and it is much better, but lots of heavy breathing and still a bit smoky..More than acceptable.

Only driven about ten miles, made a few noises, power went flat and now us sounds like a VW beetle... I'm going to check valve gaps, push rods...If that's fine it may be a bent valve, plus it needs rings..

So it's decision time...

John S · Dec 22, 2016

Turners

brian47 · Dec 22, 2016

Terry.Lane said:
valve gaps, push rods...If that's fine it may be a bent valve, plus it needs rings.....

I think you've answered your own question there. Possible head damage, drop the sump, pull out the pistons, change the rings, hone the bores, new big end shells, etc., etc. All with no guarantee?
Is it really worth it?
Turners.

Bobsticle · Dec 26, 2016

Its worth it if you dont want to part with nearly three grand for a wash and polish.

Not sure how you can qualify that kind of money for a rebore and paint.

2 1/4 diesel

Terry.Lane

Member

Land Raver

Well-Known Member

Terry.Lane

Member

John S

Well-Known Member

brian47

Well-Known Member

Bobsticle

De Villes Advocaat

Similar threads