Search results

Help Ive got a 2001 freelander 1 TD4 that wont start it will just turn over Any suggestions Thanks:confused::confused::confused:

Help I got a three door 51 plate TD4 and it's gained itself a knock at the front end not unlike a drop link knock but it's not the drop link!! I've also changed the shocker thinking it was that including the yellow bump stop, but the knock is still there 😡😡😡 Anyone got...

All Got a slight problem with my 2001 TD5 defender, It develops a vibration and slight loss of power and a very very slight misfire, this fault only comes on after half a mile start from cold then gets worse as it gets hotter Any suggestions?

All Has anyone managed to successfully fit central locking to a pre 2002 defender 90 van I have fitted successfully the front servos but struggling to fit the rear as the lock mechanism is burst proof and I cannot get into it Can anyone help with a solution Thanks in advance

All does anyone know who's the best at remapping the TDV6 engine looking for both power and economy Any suggestions Thanks

All Does anyone know if its possible to switch on the 4x4 info on the satnav on disçovery 3 SE mine is a 2008 08 plate Thanks

All I plan to fit a DID headlamp kit to my 2001 TD5 defender, therefore I need to disable the dim dip function on the headlamp as it would mess up the HID kit. Does anyone know what to do to disable this function:confused: Thanks

Help My 2001 90 TD5 won't start it turns over but the fuel gauge goes to empty and the pump isn't working Also I can't purge it could it be the yellow relay under the drivers seat? It has had the injector loom changed 12 months ago

All I have a 2003 disco and it's parking sensors have decided to be on continuous when in reverse with no fault flashing on the dash switch any ideas anyone?

Re: Clutch bleeding problems All put new slave cylinder on and fully bled now got a pedal with about 1/2 - 3/4" play at the top then pressure but the clutch still won't disengage This is following a clutch and control arm change Can anyone help? Thanks in advance

Can anyone help, Following a clutch and clutch arm replacement now I cannot get a clutch pedal at all I've bleed it a few times now I am now very frustrated Help

After refitting my gearbox I was connecting up the electrical connectors and the one for the oil pressure switch the earth has come awey does any one know were the earth goes on the body? Thanks

Help I am trying to refit my 2003 53 disco manual gearbox, get it close but it gets fouled by the insulation around the bell housing, looking into the bell housing the shaft is about half a shaft away from the end of the clutch fingers Anyone got any...

Help Friend of mine's intermittent wiper doesn't work but the rest do on his 300 tdi 90 any suggestions of why? Thanks

Help Does anyone know how to extract the brass bush from the flywheel center (blind hole) on a manual TD5 disco 2 Thanks :confused:

Help Ive got a TD5 with the R380 box in it, Last night the slave cylinder push rod failed, I can now push the push rod in towards the gearbox Can this be fixed without taking the gearbox out? Thanks Andrew :confused::Cry:

Help Just fitted a genuine TD5 rev counter to a 2001 TD5 90 I've got the signal from pin 19 off the black plug on the ecu which runs in the loom up to the dash that's were I picked up the signal from I've created the loom for the dials and fitted the rev counter but it seems to be a slow...

All Just bought a 2001 3 door TD4 freelander with a couple of problems I could do with help with, 1st The central locking is a bit iffy the system will lock but it won't unlock the passenger door on the second press of the remote 2nd The rear door numberplate light/handle has come loose needs...

Ive got a 2003 53 disco 2 with a leaky sunroof, after some investigation ive found that the connections of the drain tube to the tray are leaking. Has anyone had this before and how of you sealed them again without the expensive option of buying a new sunroof tray Thanks

Help I am going to change the ratio in my transfer box to 1.2 to get less road noise and reduce revs also save fuel? Has anyone got any tips? Thanks