Search results

All good info. When I took the MAF out it was easy to see it was at fault as one of the 2 small filiments was already gone

This would appear to be the problem. With MAF disconnected I certainly seem to have better pulling at low revs. I assume that with the MAF diconnected the ECU is on a base programme which would mean that full power is still not available. However, very happy to be moving forward Thanks

Hi folk Have a TD5 which runs and sounds well except there is little power low down. Once past 2500 rpm alls fine and acceleratiion /pulling is fine. If I hit a hill at 50mph in top it would just die and even a change down won't help unless its above 2500rpm then all goes good. I believe there...

I had a similar problem which seals and washers cured but only for a few days and then the problem started again. Another set of seals and washers later all is well. The moral of the story is as Charles says EXTREME CARE AND CLEANESS will save you doing it twice like me.

about 2 wks ago it started getting hard to start and then it ended up needing primed. I then changed the injector seals / washers and all was well - starting first go. then about 5 days later it died and requires priming again. This has been the story ever since. As the pump was noisy I put a...

Checked codes with Snap-on Modus Plus - NO CODES PRESENT If engine running sweetly and is turned off it will not start immediately again without priming Also changed relays round but no different and checked & cleaned the 3 earths at the rail behind battery

Uncle Albert The pump is working when the engine dies and then as the engine dies the pump stops a few seconds later. Without switching ignition off dis / re connect the black plug to the ECU brings the pump on just as if you had switched the ignition off and on again.

I have drove it without the fuel cap and the dammed thing still stopped. But its good to have someone throw in any possibility Thanks

Hi Folks 2003 Disco 2 needs primed to start goes perfect for 1/2 mile stops, prime again spin on starter then starts for another 1/2 mile. Things I have done 1. Fitted new pump in tank 2. New filter plus checked valves at pump head (no valve in rear:doh: left) 3. New regulator - gauze to...