Search results

buying a welder is a bit like an internet bride go for the best you can afford, the more you spend the better it will be,it depends what you want to weld, a cheap welder wont have enough power for chassis repairs, if your welding outside then a mig gasless welder would be best but you get a lot...

sell the disco and then have a trip to rimmer bros

cut the old seal out with a stanley knife on the outside,then get a mate to push the screen from the inside and it will come out,use the string method to refit will take about an 30mins

sorry meant cv joint slipping in the drive flange on the nearside,its been a long day,hard work doing mobile defender repairs i prefer the comfort of my own garage

lower seals on the doors started on 300tdi's i think, there will be some holes on the underside of the door,about ten holes on the fronts as they have pins to hold them on,the older type on the sill are best to be bonded with a rubber cement hope this helps

my rear silencer had collapsed inside , i dont know if a blowing exhaust would cause the fault you could try sealing it up to test it

diff turns half shaft and cv joint but cv so worn suspecting slipping in the stub axle on nearside

have permission from the higher power to rebuild it on saturday well till 3pm did you get the swivel ball bolts out ?

i use to have a freelander and had a similar problem took it to the dealer tried testbook no fault recorded, changed the throttle position sensor,wiring loom,idle control valve etc turned out to be the rear silencer, the exhaust gases could not escape quick enough so it was choking the engine

should have gone down the hobnob route more of a mans biscuit

sounds a little odd the dealer has said the coolant tank isnt cooling the water as it is only for feed and expansion, i would go with the thermostat stuck or the rad partially blocked,oh and yeah put brass bleds on the plastic ones sheer off

shouldnt be too bad a job its not the first axle ive rebuilt and it certainly wont be the last,will put money on it being cv joint collapsed,them new wheels will have finished it off

make sure your kettle works better than you landy ! you better have got some tea bags ! lol