Search results

I have just fitted a recon cylinder head onto my range rover and was wanting to set the valve/cam timing correctly. I marked the cam etc before I removed it and the new cam is back in the same place but need o check it was correct when I removed it? Is there anything I can measure on the cam...

I have just changed my cylinder head on my 1998 2.5dse. And on starting up initially. The heater plug light comes on as it should and the injector light comes on as it normally did. the only difference is the injector light then goes off and then back on, the engine will start but sounds rough...

Its the old faithful problem again I think. Can will sit ticking over without any problems. When it is driven for approx 10 miles. the temp goes very quickly up into the red. It is an automatic and goes into limp home. Before it over heats the temp sitS nice in the middle of the guage. hot...

I am on the lookout for a set of wheel nuts for my P38. I am fitting a set of original 16" Alloys for the winter but the holes are a lot bigger than the 18" set that are fitted. I suspect I need the wheel nuts with the 27mm collar on them, Does anybody have a set that they would sell...

Well its that time again!!. I am looking for some winter wheels and tyres for a P38. Not too bothered what they look like just to get the other half to work in the snow. Do the defender steel wheels fit a P38? if not what type do? Can anybody help or have any for sale? Thanks

Just last night I have a knocking noise from the drive train on My P38 Diesel Auto matic. It varies with road speed at was getting worse on a 50mile trip back All prob UJ's seem ok , but knocks approx every prop turn and not every wheel turn, Any ideas?? Thanks again