Search results

hi mate,the tyres in those pics are fedima scirroco 285/75 r16,they stand 33.5" tall and 11.5" wide and are on 30mm offsett deepdish modulars

if you could upload a pic people will be able to give you a definate answer :)

just re-read thought it was 1 wire,as above if its 3 small wires there will have been a switch hard wired to the cab to operate the winch

on the bottom of the winch motor there should be an earth stud(3 studs on top,1 on the bottom),it may go to that

theres one on at holymoorside on the 16th

sorry to hear of your finger mate,and your alternater should be 65amp,apperantly a 300tdi 100amp alternater will fit if you swap the pulley over or some ford v6 engine alternaters will fit

ive got a goodwinch tdsi goldfish,my trucks an offroader ive had the winch submerged many times,plastered in mud,when we had the snow it was covered in ice,the winch has never let me down,i stripped it recently to grease the gears up etc and to my surprise inside was still like new,i really...

I stand corrected :) maybe this will help people in the future List of Serial numbers and corresponding Ratios All stock LT 230"s have a low ratio of 3.321, the following list refers to the high range ratio. 12D = 1.667 LT 230R 13D = 1.410 LT 230R 14D = 1.003 LT 230R 15D = 1.192...

forgot you dont want 1 off a v8 disco as the ratios are too high

any manuel disco lt230 transfer box will be ok (200 and 300),it was only the borg warner (rrc)that had the viscous coupling rather than manuel diff lock

Ive recently fitted a KAM in my rear axle,the simplicity of it is great in how it works,the only down fall is that you have to modify your back axle slightly but its easy if youve got access to a welder,KAM lockers are a lot cheaper than ARB'S and you dont have to buy an air compresser,im...

:pop2:

If theres no squeeling or grinding noises then the bearings may be ok,may just need the hub nut tightening up to take up the play(vertical),the swivel play (horizontal) you may be able to remove a shim or two to take up the play as for your sisters im not fussy i'll take either 1 :D

Dont know if it will help you but i live in chesterfield and work all round nottinghamshire daily,so if there isnt any one from derbyshire but is from notts that travels south it may help

i meant genuine gkn hardy spicer,they do a standard or heavy duty cv but cant find anywhere that supplies them

sorry to jump the thread but does anyone know where i can get a pair of gkn hardy spicer cv's at a reasonable price? from personable experience i agree to stear clear of britpart for anything to do with the mechanics/running gear of your landy,i would only use britpart for accesseries

personally i think k seal is great,about 4 month ago i got a little hole in my radiator (200tdi 90),a mate recommended k seal so i used it and it stopped the leak,a week later i stabbed the radiator with a 2.5mm drill bit in my drill (by accident) and within a minute the leak had stopped,that...

More than likely a bad earth somewhere,a bad earth can cause allsorts of wierd electricall problems

nomad bumpers look just as good,me personaly i prefer the close fit as they dont overhang to much but like you say you have to cut the grill to fit the winch,the goodwinch is the first one ive had and im really impressed with it,highly recomend one,its got a fast line speed,waterproof and pulls...

its an extreme 4x4 bumper(formely scorpion raceing) and goodwinch tdsi goldfish winch,the bumpers a non aircon version so its quite a close fit so you have to cut grill