Search results

OK the other halfs td4 would not start, narrowed it down to the regulator on back of high pressure injection pump. Changed seals and started fine ran OK but now when car is up to temp it goes into limp home mode and eml is on. Error code is "4496 rail pressure monitoring deviation" Could the...

Has any one got a duff TD4 turbo that is surplus to requirements as I need an actuator that controls the veins (waste gate in old money) Some beer tokens waiting

OK the TD4 has been running perfectly with her new set of injectors. That is until this week, no boost. The rod that is attached to the variable vein mechanism moves freely, well sprung resistance. I put constant vac hose from boost solonoid to diaphram but it does nort move. So either...

Right just fitted new wheel hub bearing assembly, fairly straight forward. Took for drive abs light went out after the magic 8kmh. Took it on A14 yesterday cruising at a good speed touched the brake pedal and abs kicked in very scary as no feel to brake pedal took foot of pedal re-applied and...

I have just rebuilt my front prop shaft and as people have advised onhere the Self centering bearing was in a bad way. So following the instructons I found on here found the process fairly easy. Anyway I have two new sealed precision 617 self centering prop bearings. (I ordered three to try...

Well we still have a gutless Freelander? Had new Maff new pump and filter, changed fuel rail sensor as it was reading 3 volts at 3000 rpm, I read somewhere that it should be 2 volts (still reads 3 volts). I rigged up a two volt supply to sensor plug and it seemd to rev more willigly but could...

Hi hoping someone can help, got a 2003 td4 that lacks power. It seems as if it is under fueling. Maf was changed with new Bosch item as the one that was fitted had a broken temp wire, also replaced map sensor. If you put your foot down the revs climb gradually in every gear but the higher the...