Search results

Hi bud, just done this job on mine...removed rear seasts,as it says in the manual...no need. Simply get a stanley knife and cut two lines through the carpet,down between the rear seats(when they are down).Pull the carpet from under the reast door strip,and there's your access plate. Remove...

Hi folks, Thanks for all replies.. In response to your reply,Del, I had thought of fuel pressure regulator,as my next port of call. Did a fault code read,and nothing there at all. Dunc.

Thanks guys,have a diagnostic reader that previously came up with excess boost,although the boost chip kit stops the management light coming on,and going into limp mode-i haven't checked it for codes recently,though...one thought about insufficient air through airflow meter...I haven't cleaned...

Hi folks, Had an ongoing problem with my TD5 on starting from cold. To start first thing(the rest of the day is fine),I have to floor the throttle and turn over for about 5 seconds or so,the it starts sluggishly,idles properly after about another 5 seconds,and gives off an initial cloud of...

Hi folks, I recently had a new transfer box with manual difflocks fitted to my 2003 TD5,but unfortunately,the company cannot get hold of the necessary kit to convert the diff gearlever to enable difflocks to engage(the standard lever only selects high/low,whereas I need to select high/low &...

Hi, This may be a longshot,but if the car has done high mileage,the cat may be collapsing,causing a restriction to the exhaust system...unfortunately,when this happens,the harder you load the engine,the more it struggles to rev. Hope this may be of help. Regards, Duncan.

Hi, thanks for your rather short reply,but the ecu's already been remapped by TD5 Alive...any other ideas??

Hi, Has anyone fitted one of these gadgets that allow greater turbo boost? I know without it,the ecu can go into limp mode if the boost is above 15psi,or so... I'm told I need to increase the intercooler size to get best results,but I'm thinking of fitting one on its own,and screwing the...

Hi, i recently completely removed my EGR valve,fitted blanking plate to manifold,and removed vacuum pipes.....don't think there's any noticeable difference. Good luck with yours.

Hi again,guys, Thanks to you who sent messages to me for the problem with cruise control and horns...fixed!! Seems that the fuse to the horns had not actually blown,but "ruptured",so once changed,my horns worked....strange thing is,so did my cruise control. Maybe there's a part of the C.C...

Hi folks, Just joined,and wanted to say hi from Droitwich. owned various Land Rovers over the years,a RR Vogue,Disco1 diesel,two Disco1 V8s,and now a TD5 Disco2,remapped by gary at TD5Alive...Bloody Great!! Hope to hear from you soon. Jellycream.

Hi guys, I've only joined today,and am hoping someone out there can help! Whilst my disco was off the road recently,due to cylinder head replacement,the alarm mysteriously went off in the middle of the night..seems for some reason,the battery went flat..since then,the cruise control or the horns...