Search results

Hi eightinavee I had the ECU reprogramed and my disco fired up . Thanks for helping me find my problem

Hi Eightinavee It sounds like the next step is to find a complete wiring diagram for my car . would you know where I can find a diagram for downloading . I have looked and can not find one .

Hi eightinavee I was going over one of the past replies and you asked if I have a passive immobilization coil around the ignition switch . not sure how do I find out .You mentioned a alarm/immobilizer ecu from what I understand if the alarm ecu is working right it will send a signal to the...

Hi eightinavee thanks for the further information that you gave me . I mentioner that I had no fuel pressure and thought it might be the pump . I tested the pump and it tested out ok the sending unit is not . I replaced the fuel pump relay and the pump works again . Well that one thing fixed...

Hi Eightinavee after the engine stopped I started doing the normal little checks . Of course I found nothing . I then removed the ECU and I found the bottom had rotted out . Seeing this I bought a good used ECU with all the same numbers as the old ECU . I,m thinking now , will I have to get...

Hi Peter My ECU is a GEMS 8 the crank sensor is a new Land Rover one. The camshaft sensor I have no way of checking out the unit itself . I have power to it though I would think that this is a start. The rest that you mentioned to check I will get at that tomorrow and I will get back to you

Hi Eightinavee the ohms reading that I gave you from the crank sensor , is from a brand new land Rover crank sencor that I have in there now . The only reason for the AC volts test was to make sure that I have a air gap for the sensor . and that it was working I did realize that the rpm...

Thanks for the reply Nathan5346 I have a 1996 disco SE 4ltr V8 series 1 . The engine that is in it is it's original engine .

Hi Peter The 4 Ltr v8 I have has the coil pack

I have a 1996 Disco 1 4 ltr V8 with no spark . Tests that I have done are as follows . At the ECU there is power to all the multi plugs . There is power to the ignition coil . The ignition coil was checked and they are good . There is power at the camshaft positioning sensor . The crankshaft...