Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. dirtyrhino

    Series 3 truck cab complete

    Landrover Series 3 TRUCK CAB, Inc TRIM, TONNEAU COVER (88"), and tension bar. After deciding to sell my beloved Landy, I got a LOT of stick from my friends, who have (somehow) managed to convince me to keep her and do some minor mods to make her a bit better for my knackered back. One of...
  2. dirtyrhino

    Chuffed to bits... S2a, V8.

    **slobber** always wanted to do a V8 conversion....but all that grunt pushed through either weak shafts or an underspec'd gearbox and then being stopped with drums always makes me kinda twitchy.... reminds me of the amazingly terrifying torque steer in my mates 2ltr mini conversion...... :D
  3. dirtyrhino

    Loooook

    ....say Whhhaaaatttttt ??????..... :pop2:
  4. dirtyrhino

    Loooook

    Ok, how about 700 and a complimentary slap round the chops ?:rolleyes: "Daily drive" - ? and your after a bobtail ..... .and cant be arsed to upload pics.....or give a decent description of work carried out, condition, work required.....
  5. dirtyrhino

    Loooook

    ......i'll give you 650 for it.....:rolleyes:
  6. dirtyrhino

    Anyone want to swap / p ex my truck cab for a hardtop and sides?

    Thanks lads - again, Landyzone members rally to the cause once more :D Thanks to Paul ( PEF77) i now have a set of sides and a roof waiting for refurb and some seals - so all taken care of :) HOWEVER - if anyone would like a truck cab, complete with canvas tonneau cover and inside cab trim for...
  7. dirtyrhino

    your land rovers name

    mines got a lot of names, none of them repeatable on here, but mainly "Smidge" - mostly cause when i covered in oil/****e/mud/grease/horse crap and my mate says "you done it yet?" i usually say "just a smidge" .........
  8. dirtyrhino

    Anyone want to swap / p ex my truck cab for a hardtop and sides?

    pef - gimmie a call dude - i sent ya a PM ;)
  9. dirtyrhino

    Anyone want to swap / p ex my truck cab for a hardtop and sides?

    soz - i do that every time ! I'm in Weston Super Mare, just south of Bristol.
  10. dirtyrhino

    Anyone want to swap / p ex my truck cab for a hardtop and sides?

    As the title - i'm sick to the back teeth of having a truck cab - seemed like a good idea at the time - until i found i needed the inside space on my 88". I'll include the swing away rear carrier, tailgate and (very expensive) canvas cover if it helps secure an effortless swapsie.... Jazza.
  11. dirtyrhino

    Series III PCV system...remove?

    .....blowing or sucking..........so many jokes, so little time :D The breather would normally be blowing into the PCV system/valve, and then from there feed into the manifold, aditionally being pulled on by the intake flow of the manifold, recirculating some of that gas and air mix from the...
  12. dirtyrhino

    What have you done to your Landie today.

    Filled it with junk for the tip run tomorrow, fixed the ****ty earth for the fan, adjusted the timing a smidge, found more crap to put in the back....
  13. dirtyrhino

    Series III PCV system...remove?

    Screw the PCV system. I generally pull the **** off as soon as I get my grubby mitts on an older (unmanaged) engine. As long as the block can still BREATHE you'll be fine. HOWEVER. stuffing the breather in the intake pipe will force all kinds of ****e into your carb so, just I route a pipe...
  14. dirtyrhino

    Electronic ignition on 2.25 Petrol

    Seconded. Very worthwhile - and while your in there - fit a leccy fan ;)
  15. dirtyrhino

    petrol to diesel linkage help please

    Now see, when i went from diesel to petrol, i had the opposite problem... i THINK i've got the old diesel linkages kicking around in the workshop.... post a pic of your current setup fella :)
  16. dirtyrhino

    Removing stupid steering relay

    There's a vid floating about on youtube of some dutch (?) chap using a puller and a fook off breaker bar..... Land Rover Serie - Steering relay extraction - the easy way out - YouTube
  17. dirtyrhino

    Series 3 rebuild

    lolz - it's all about Life Skills - your doing yerself a favour - common sense, working things through, attention to detail.....first aid...patience....budgeting....fadvanced first aid....welding....burn treatments... the list goes on :D Theres only so much you can learn when yer out at night...
  18. dirtyrhino

    Series 3 rebuild

    Been watching this one fer a while - Gotta say - it's awesome to see a young'un doing something CREATIVE with their time for once. :D Fair shout to ya lad !:clap2: Jammy sod, having a nice, big workshop....AND lots of toys ! :pop2:
  19. dirtyrhino

    need project

    heheheh - I wondered when someone was going to mention it.... :D:D:doh:
  20. dirtyrhino

    Started Resto work on my S3

    I've been quiet on here for quite a bit - sorry about that. Things have happily moved forward at home, so the old girl is staying :) So well in fact, i've managed to find a V8 to fit next summer......... :D Now, whether I put it in smidge, or find another landy to rebuild is another question...
Back
Top