Search results

Somthing not right then.

Ok just done again up to 20psi. When you open bleed nipple no fluid comes out. So just done it the old way press- open - tighten - release. Fluid comes out no air. Took for drive it brakes. ABS kicks in. But still think pedal is spongy. When under pressure would the fluid come out straight...

Ok thank you for the reply and help I know its dragging on. I've used the sealey pressure bleeder today I've gone with the old order of bleeding starting at rear passenger pressurised to 10psi. Attached no leaks ,cracked off rear bleed niple no flow! Pressed peddle fluid out but only when brake...

Ok thank you. I'll look at the autel ap200.

Hi the way you describe bleeding is what I normally do. But read from an online manual for range rover to do it the way I did. So bit confused. Looking at that sealey blender kit online. Does the cap that comes with it fit or will I need another size. And if it does need abs diagnostic bleed...

Thanks for reply . I use to do it furthest away on the older cars I do. But I read on here in online manual. To do passenger side front first then drivers front then passenger rear. I.do like them spanners will have to purchase them.

Ok new brakes lines all round fitted. Couple of expensive line clips needed. Bled the brakes front left, front right, rear left, rear right. Brake lights on dash ! drove car round yard Lights go off and stay off, But now the brake when first pressed goes to the floor slow then press again and...

Hi I know it's a while ago but trying to do my lines I've got a 2005. But looks like lines go up behind the fuel tank. Did you need to drop your tank?

I know this was years ago but I'm doing the same, also think I need to drop fuel tank. How did you get on in the end.

She would phone RAC "cars broke just cut out wont start" lol

It's the miss's car so it's a good guess theres no fuel on it or very low. As she thinks its magic. Every time she gets in it's full. Lol.

I've got a l322 2005 3.0 range rover vogue. And mine does the same. It never use to do it. I've been told it's the new pumps being installed are delivering fuel faster and the older RR cant cope with the speed. Hope someone has found the problem if not this and fixed it.

Hi after needing to replace fuel lines I've found they come down passenger side and up over the corner of the fuel tank and across the rear axel. So to replace I thinking I need to drop the tank. Does anyone know how to do it and what to watch out for like connect plastic clips that need...

we had similar. No radio no screen nothing . Bypassed the bt with ebay loop fibre optic and it all came on. Hopefully it's that.

Brake lines down passenger side look ok. But now more concerned with bodywork. Where would I get panels from for these. The cover along the brake line was held on with some strange clips look like allen head/torx fitment but just pulled off.

I used a piece of rubber a wooden block on a trolly jack. Ive used another jack to lift support the wheel/ air bag just to be safe.

Well managed to grab a spare hour on it today. Ordered new flexi pipes new nickel copper pipes. It will be a full brake pipe overhaul.

Ok thank you it makes more sense now. Just the jacking up part to sort out now without damaging air bags ,thank you for all the input everyone.

This is drivers rear side so is it a solid pipe line over to passenger side then they run down to front under cover?.

Are the lines running down passenger side under plastic. Few comments have said drivers side to a connector at front?