Search results

Hi all. Replaced cambelt and water pump. Now trying to bleed . Followed Haynes manual and noticed that the thermostat is not full of fluid and heater is sloshing. Ran for a minute to see if it helped push it around. Do you need to keep the reservoir level from uncovering the feed pipe to avoid...

I was sceptical myself. But after reading other threads that said they had success, I tried it. I can confirm that it does work. Locks are now operational for £6.

Just heard from supplier, if I take the brush head off and turn 180 it will go opposite ways. We'll see .

The passenger door wasn't unlocking at all before.

Hi All. After changing a passenger door lock actuator motor. This door now locks when unlocking and opens when locking with the remote. Not sure I got all the levers in the right place. Or is the motor running backwards. Needs syncing? Got motor from Ali express for £6 against £120 for new lock...

Update. Fuel pump removed and found seized. Managed to turn the impeller to free off with wd40 . Put wires straight to battery and whizzed round nicely. Refitted , still no joy. Che cked engine bay fuse for pump. All good. 😊 Then found 2nd fuse under steering wheel blown. New fuse and away...

Thanks. I shall check that . Don't remember hearing the pump run with ignition on .

Does the 1.8 have a priming button ? Will find out Monday.

Had the seats and carpets out , with all the trim panels. Did notice that the HDC switch wiring on the gear stick has broken. This wouldn't stop it syncing and starting would it?

Haha. Battery is two months old and has been fully charged.

What do you mean.

Hi , Freelander 1.8 . after a month or two with battery disconnected for maintenance and interior stripping And cleaning. Reconnected battery and didn’t get the tailgate window going down . Also no start. Engine turns over strongly but no start. Tried five clicks on the remote buttons , locks...

Been looking for the normex with both sets of formers. Now 60 odd euros.

Thanks for the link. Just what I needed.

Also my eezibleed kit doesn’t have a cap to fit the reservoir. (Quarter turn bayonet). Seen new vacuum pump bleed kits for £15 .

Drums are looking good. Hardly any ridge on edge. Shoes have approx 4 to 5 mm lining left . Cylinders looked dry however are very wet under piston outer seal. Will order two new cylinders. The brake pipes are pretty bad .New flexis required. Big problem is the long rigid pipes clipped to the...

Yes. Hired a trailer to pick up. Quite a first time towing 2 tonnes.

Found the top rad hose chafed against the fan shroud today. So thin it's ready to pop. Good job I've got the new hoses

It's an assembly of new coolant pipes with a new thermostat , which moves the position of the stat to front of engine and gives a more stable temperature. Also seen a vid of a different way to plumb it in to avoid any overheating on a 10 minute idle. Hopefully stop any hgf problems in the future.

Hi All, I have just bought a Freelander 1 1.8 k series 50th anniversary 3 door as a project. This is my first landrover and I have read lots on the forum already. I have done a compression test and found 230, 220, 230 and 230 which I am happy with although seems a bit high. Will be doing the One...