Search results

hello all, im here to ask yet another stupid question :) ive fitted a full leather interior today in my FL1 but i am having an issue with the rear seat behind the driver (so the bigger of the splits) it will not go back up from folded, it will only lift about half way then seems to jam. the...

no expert here so im sure someone else will correct me - i think the crank sensor is where you should look next as the ecu will not fire the injectors if it does not have an rpm signal - does the rev counter needle move when cranking (this isnt a foolproof check not all cars do )

doesnt seem like any obd reader will connect on mine, but delphi can talk to the ecu as can mems3mapper/flasher - im actually beginning to wonder if cars had a very dodgy remap tried on it

well thats a no go on my car, torque never connects to the ecu. neither would my topdon smartdiag mini either though. only diag ive managed to get to connect is delphi on my laptop.

thats what i expected, its all good that doesnt worry me too much, what does worry me is the fuel economy, averaging about 60-75 miles on quarter of a tank. also got a fairly constant smell of fuel while running, now i know the exhaust flexi will be the cause of some of this but i am still at a...

that makes sense, i doubt the mems3 ecu supports cruise :) was more interested in a trip computer to be fair but ive never seen on on any freelander as far as i am aware

already got a bluetooth dongle and torque haha need it considering my other cars heavily modified and i dont trust it :) will give it a try tomorrow

id say its possibly low 20s - high teens . i got roughly 40 miles from id say about 2/3 of a quarter of a tank - not exact numbers i know haha but i havent done proper mpg calcs yet. how would i go about checking timing, i have the upper timing cover off already from fitting the replacement...

ok on a related note, ive cleared all the stored codes on the cu and only code thats come back is the camshaft sensor (i have one ordered to pickup tuesday) and fan circuit2 ?. also when i rev car i can smell fuel. dont know if this is just because flexi needs done or if car is running rich as...

wheres the pump on these, im assuming you mean in the tank? will do, mainly took the shaft off to see if it helps mpg and because i want to get the shaft checked properly as it has got a lot of marking on the engine end from rubbing the exhaust so i want to get it checked for balance etc - have...

yep im aware its low powered compared to my other vehicle so that doesnt worry me too much, and i cant be certain 4wd was working properly since theirs rather a lot of grease splattered above where the prop went into the ird is it at the front ?

hello everyone, my first post here as i have just been gifted a family members old freelander 1 1.8 Xei. firstly i want to say im not afraid of the known issues with engine nor mechanical issues in general. but now that ive had the car a few days ive got a few little issues that i could use...