Search results

I’ve got a rats nest in the dash as well, I need to make sure I have gotten all buttoned up. Right now it’s a little daunting. Perhaps sim help in this realm is needed as well, but working on it daily.

Looking for the solenoid wire to disconnect, simultaneously trying to identify some wires so that it’s all connected up and ready. Specifically the brown wire with washer end, and the wire bundle near my hand (assuming it might be for air conditioner (which this landy doesn’t have). Thanks for...

Gents, In the photos depicted, I am wondering why there is an "extra" dowel/tapped sleeve to the lower right of the stud. I snapped my front cover when attempting to remove because of this. This is my first timing belt change on my disco conversion defender 90. It is a 200 TDI 12L engine. Is...

All, it has been around 6-7 years since this engine has been started. Started on a project where I had to remove and replace the bulkhead (poor purchase decisions, but learning a lot). I have a new wiring harness and such that I will need to install at this point however, I am already looking...

I’m trying to figure out where I can buy the correct dipstick for the disco 200tdi, I bought part#ETC7867, not even close. You fit a defender 200tdi to your discovery 200tdi engine? Does this reflect accurate oil readings? Or does anyone happen to know the correct dipstick part number for a 12L...

Hi all! First post, I have a defender 90 disco 200tdi conversion. Just ordered a dipstick replacement for and it does not seem to fit at all. The old one broke but had a green top with finger hole. The one I bought is part #ETC7867 after describing it is a discovery 200tdi it was identified by...