Search results

Hi I’m looking for a recommendation for a good garage to ‘fettle’ my Series 3 please. Any where in the South West Thanks

Hi 2.5 petrol engine I’ve changed the plugs, leads, distributor cap, coil. But she is still up and down on tick over and cuts out. I’ve adjusted the idle screw to stop cutting out. It has a red plastic electronic unit - don’t know the make. Engine is settled when revs are picked up Can’t set the...

Hi I’ve got a Series 3 with a 2.5 petrol engine in it. What carb should be on it ? I think the previous owner has used a carb off a 2.25 Can you help re Webber model ? I’ve been told twin choke then others say not - Confused !! Cheers

Hi Weird Series 3 My bonnet will not close. Replaced the slam plate and lever but the rod from the bonnet is still 4-5 mm to the right and there’s no play to line up. I’ve loosened the bonnet hinges. There’s a rubber bush missing from behind the rear bonnet edge - any thoughts helpful. Feels...

I have a swb 88 series 3 I’m wanting to change over to a cab and 3/4 canvas. I have hoops for a full canvas Can I use these? Did the car come with hoops mounting holes to take both a full and 3/4 canvas set up. She still has the hard top on. Cheers

hi Lever moves fully to the right - bonnet is partly released but not freed- must be still catching How do you release the bonnet :( Thanks

Hi Landy was attacked last night - smashed drivers window but they didn’t take it away Is there a quick release steering boss that anyone would recommend ? Just bought a claw clutch Cheers :(

Hi I’m trying to source the rubber seal that goes along the width of the car flap door. It’s the one that’s held in place by a trim on the door itself. Thanks

Hi - new member and first Land Rover I have a 2.5L petrol conversion Series 3 -Carb - zenith copy is connected to a Defender pedal via a cable. The pedal is sitting too high to drive with. Is there a conversion kit or mod that I can do to solve this problem? Or shoukd the standard Series 3...

Hi I have a 2.5L petrol conversion. Carb is connected to a Defender pedal. The pedal is sitting too high to drive with. Is there a conversion kit or mod that I can do to solve this problem? Any help appreciated.