Search results

Hi, I have this problem with my 90 which feels much like the diff lock seems to engage and disengage on its own. I'm wondering if the centre diff is about to fail? It happened over a couple of days after which i removed the front prop shaft so I could use it to get to work as didn't want to...

Hi, simple question - I can't remeber whether I put in ATF or MTF into my lt77 last time I replaced the oil. I want to top up the levels but dont know what to use. How do I identify whats in there already - do they look or smell different? Thanks

Can anyone help diagnose this: Driving along and had sudden loss of drive. Here's the info Engine running, clutch down (feels ok) into gear (any gear)and when i lift the clutch up, there is a sort of cog not engaging noise. I'm hoping its just the clutch splines broken off but the noise sounds...

Hi, what size pipe should I use from the air filter to the turbo - can I get away with 51mm tubing as that all I have really and thats what is from the turbo to plenum. I'm not using an intercooler. It looks like its 60mm on the turb going in so would need a reducer. thanks jeremy

I know its been covered a zillion times a zillion different ways but... I'm on a tight budget so bodging is a viable option: I need to change the PAS pipe lengths - Can I use 8mm compression fittings/copper/steel pipe? For the reservoir pipes, do these need to be special hydraulic material to...

Any help with this one? I have a 2.5 n/a which started making quite a loud noise. Checked oil and noticed it was blow min (no light on) Anyway, topped up with oil and the noise is still there. Initiually thought it would be big ends/mains worn due to lack of oil but I now think its coming from...

Hi, where do I start with this on please. Intermittent power loss (maybe a second or so) when driving - appears worse at higher revs. Feels like complete fuel starvation. Also, during idle, it can happen and engine will be cut. I have blown through fuel line from lift pump to tank. No difference...

Hi, I know getting the hinges off can be tricky but can anyone recommend an online supplier of a pozi #4 bit with a 1/2 socket so I can use an impact wrench? I'd like to replace these fasteners and stop the door sagging and possibly replace the hinges. Also, is there any use in drilling some...

Not sure where to put this... In this snow I have difficulty getting up my drive (its a 90)and was wondering the best way to do this. Its about 30feet long, flat on the top and I take a bit of a run at it. Normally I would select diff lock, 1st gear and see how far I get up, when I loose...

Hi, I'm doing a cheap and cheerful rolling restoration of a 90 and I have a number of areas on the body (bottom of rear door) where the aluminium corrosion is so severe I can poke a screwdriver through to the door frame. Whats the best way to deal with this? I'm only really trying to...

I have a recon 3 bolt steering box and has a leak from the steering box/pump union on the steering box. This is really hard to get to to tighten fully. Is there a tool I could get to make this easier - I dont want to take the steering box off again just to tighten this joint? Any Ideas...

I'm looking into doing this as my chassis is in a terrible state. Its a C plate 90 2.5N/A and never been waxoyled. Are there any publications that describe whats involved and does anyone have any job lists/advice. I will have to dismantle the body as have no way of lifting high or use of any...

Hi Folks, I need to pump between 300 - 500L from a tank to a water barrel at least once a week in the summer. This needs to be a cheap solution. I have a LR 90 2.5 N/A diesel and there is plenty of space in there to possibly attach a 2nd water pump to pump water from the tank. I'm guessing I...