Search results

Set ordered and money saved. Thanks gor the link to identify them.

It's all good fun and I'm thick skinned not fat lol.

Good bit of info there thank you. I assume the price difference is between audible and non audible from the descriptions.

Discuss what the differences are or might be.lol

Afternoon all hope you can advise on this 110 Defender 2002 hard top with basic spec. I need to replace the front seatbelts but find that when I search for td5 ones the price increases substantially. Why? There's no dash warning lights or pretensioners etc so I'm wondering what the difference...

It's my understanding that nanocom can only talk to the ecu IF it is NOT already immobilised.

Just a quick update guys. I bought the 110 so lookout for more questions doon.

I wondered about Abs surely at 02 it would have been std? It's on my 03 disco.

Good morning everyone. I currently run a disco2 but always hankered for a defender 110. I have nanocom so all good on that front and a very strong electrical and mechanical background. The question is does the td5 defender 02 plate only have ecu control on the engine. What about a bcu or abs...

Hopefully it'll go well. I've already done all the loosening of bolts etc so should be quite straightforward on the strip down. Been thinking a lot about the measuring. Maybe overthinking though lol. Time will tell.

Hi guys im about to embark tomorrow on a 1/2chassis replacement in my d2. I have a couple of concerns as follows. I intend to support rear of vehicle by placing a support across the chassis from side to side just in front of the rear trailing arms. I concerned the body structure may droop after...

Does anyone know how long the slabs timer runs when the ign is turned off?? To clarify I had a flat battery. I thought Id do a drain check and found that after turnining everything off there was a current draw of around 1/2 an amp. I've traced this to fuse 11 (30amp) in the engine bay. Remove...

Thanks.

A quickie question before I but but are the front and rear anti roll bar clamps for bushes the same between the ace and non ace bars ? With the bushes being different. Thanks in advance.

Thanks for all the replies folks. I'll get on it at the weekend.

So to clarify. Fit 2 new bump stops. Then space axle at 61.5mm both sides by removing air from bags and supporting body with 2 jacks one at each side. Then "get current readings" then "get current heights and save heights. And that's all.

Well I have just fitted 2 new front springs as well. But they're heights are fixed and non adjustable.

Yes good shout

They wouldn't be the original bump stops anyway. Is it as crucial as that.

One bump stop is missing. So I set other st 61mm as it was as close as I could get. Then levelled other side with spirit level on roof rails at rear as I have full length roof rails I would have thought that I was near enough at 61mm but maybe not.