Search results

I have fault code saying low voltage on the nsf abs sensor, swapped for new one but not fixed it. I want to test if there is a break in wiring from abs connector to back of ecu, is there a wiring diagram for the connections on back of abs module?

I have the three amigos and fault says low voltage on NSF abs sensor so fitted new one but still showing fault. I want to test the wiring at back of abs ecu module to see if there is a break in wiring from nsf abs sensor does a diagram exist for wiring on the ecu please

Bearing not seized its a mystery

Its taken a long time to mismatch its been in at least 6 years lol. R380 gearbox and 300 tdi. I wonder if the staple securing bearing failed first or if arm cracked first.

https://www.dropbox.com/s/8s6ci99ax6zuj9b/20141215_131201.jpg?dl=0 Reason why i couldnt operate clutch! Clutch arm cracked and release bearing chewed! I wonder if bearing disengaged from arm first?

Yep im getting there im on nights and looking after my toddler in the day so it takes time i am ready to drop the gearbox back tomorrow and look inside clutch. I am almost certain it will be the clutch arm again will let you know when im in.

Thanks for all the replies

Yep i can select gears with engine off. Then start and move with no clutch slip. Bite point on the floor.

I have a 97 defender csw 300 tdi A few years ago i replaced clutch due to clutch arm wearing through on pivot bolt. This time pedal moves up and down and i can ram it into first then nothing else! I have tried adjusting it at master cylinder to no avail. Pedal moves up and down so is it...

Wow that was quick! Thanks i will do it.

How and what do you use to stop the windows rattling please

Many thanks for that you were spot on! I've fixed the monkey spanker!

Whilst driving round fields last night headlights stopped working (not fuses blown) side lights work and high beam work when i flash them using indicator stalk but when i turn headlights on ALL lights go out?? Any ideas please (earth strap is ok on chassis)

Do you need to apply a primer coat before top coat with this military type paint?

I had a similar problem. I found the fault by going to back of truck just behind rear cross member on off side where wire bundle exits chassis i pushed and pulled bundle in and out which would fix problem, it showed me that 2 wires had worn through inside chassis and were earthing, i replaced...

Thanks mate but my little willy wont reach:D:D:D

Is there any way to stop defender door locks and door buttons freezing:confused:

Thanks very much.:)

how do i bleed the clutch on my 300 tdi? i know where the nipple is on slave cylinder, do i just open it or do i have to open and close it whilst pumping pedal?