Search results

When on a student budget, one can only dream of cheap, trouble free motoring. 🤣 Especially after the amount of work put in over the last few years 😂

Ah no bother, I've just found your original post from before you changed the crank pulley and looked at the pics Arctic2 put up. Seems I was trying to do the bolt at the back of the spring loader tensioner part rather than the bolt that holds it to that little spring bar. That would be why it...

Following on from escapades with rear door not opening and window not going down when wanting to get to tools to put a nice new steering wheel on, did a few maintenance and needed jobs. Changed the diff oil which had some water in (assuming form the recent flooding and fun) and was like iced...

Did the test today to check VCU Supposedly a Bell rebuilt unit bought from a breakers 4 years ago. 1.2ish m with 5kg milkshake syrup jug 😂 1:34 going forwards on car that had sat overnight. Little long but good enough and hopefully confirms poorly diff mounts are due to Britpart cheapo's.

Did you manage to solve this? Have the same issue, 24mm nut just spins with no end in either direction. I put a dot on the back nut and spun the 24mm one around a few times, went back and the back nut dot had not moved. - I'm not sure they're linked. Managed to wrangle a flex head ratchet...

They are behind the bumper. It will be attached to a small plate bolted to the crashbar on the the drivers side. Don't know where to get one which is a pain as that's a problem I'll be facing if it gets any colder. Circular featureless sensor with a two pin plug. Must be a simple close to...

The plastic bits are on the glass and frame itself. It comes unclipped then you can take the screws out and the whole glass panel lifts out the top.

Had the same problem when I bought mine. I ended up using a pair of gate hinges which happened to be narrow enough and a piece of inch thick box section to space it high enough. Then used trial and error to get the angles correct. Would recommend drilling the holes in the bumper first and then...