Search results

Hi all, Thought id give a follow up on the conclusion. Having resolved my shock absorber discrepancy and replacing the height sensors with Dunlop OEM ones, I then re solder all the wires behind the front footwell panel and this has cured it :) . My opinion for what its worth is the corroded...

Hi all, quick update whilst awaiting new height sensors I check the connectors in the foot well for corrosion as previous posts and found the attached, a couple of pins were so corroded one fell out of the connector! List goes on.

Mine haven’t turned a wheel yet 😡 am I safe to assume the Britpart ones are OK ?

Yep £25 each from Ebay, that will teach me. I’ll try to do some tests with the multimeter to see what, if any resistance I’m getting but I’m not very good at electrics. Annoying if both have failed though.

Yes FL sensor RL sensor & RR sensor faults which is all since they were replaced.

Hi all back on line, interesting reading re setting the heights. I cannot get that far unfortunately, if I press the EAS unlock and clear the faults it goes straight back into fault mode when I unplug and reset the comms code as per the instructions so it’s still sitting on the bump stops. I...

Umm, I need to go and check now, but they did inflate and stay inflated whilst i was trying to level it with the software so the system worked, albeit I never got them to level before they went back to the bump stops. I've got a feeling you could be right. I'll go back out with the software...

I would like to say yes but its been up and down like a yo yo for the last two weeks whilst I investigate, I think when i eventually did get air in the system the axles were supported on the ground with the chassis weight being picked up on the lift so there was no pressure on the system.

Hi Mark, that's what i assumed but they crease up like an empty crisp packet. I did replace all the shocks, that's the nearest i got to the compressor & valves housing. I did use a 2 post car lift to do some work under the car so wonder if that would have done any damage?

Sorry for what may be a stupid question but why does my air suspension seem to suck the air from the bags rather than fill them up? I've changed the rear ride height sensors and front bags only so all pipework from the valves are on correctly. I've been using the RSW software to set the system...