Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. J

    P38A ABS sensor removal

    so guys, done, finally. My solution after trying everything else. 1. Cut the top off the sensor 2. Tap the edges of the remains of the sensor in to the housing so that they are away from the edge. 3. Using an appropriately sized drift (I used a drill bit), hammer the hell out of the sensor...
  2. J

    P38A ABS sensor removal

    Ironically, the hub was easier than I expected. It's the pesky little sensor that's holding me up!!
  3. J

    P38A ABS sensor removal

    I would never be arrogant enough to think I know it all Mark so no worries about eggs and Grandmothers -lol I was replacing the hub (using one from spare axle) as the wheel bearing was u/s. Gave up trying to remove the sensor on the car and just pulled the hub, which destroyed the sensor in...
  4. J

    P38A ABS sensor removal

    I have a spare front axle but so far I've destroyed one of those and one in the axle on my P38 sensors trying to get them out. I could end up destroying all three at this rate!! At the moment, I'm still no closer to removing an ABS sensor without destroying it. It's a big world and there must...
  5. J

    P38A ABS sensor removal

    This is where I've got to but the outer still won't come out and I don't have a drill bigger than 10mm and I don't want to damage the hub.
  6. J

    P38A ABS sensor removal

    My next step is a hacksaw in the same way you remove a tight bush outer. Trust me, I've dealt with a few tight bushes ;-) lol
  7. J

    P38A ABS sensor removal

    heat? Possibly but don't have any atm. Patience? all gone, Prying and rocking? Hang on , just going to check Hell.... Nope, no cats. :-( I can't emphasise enough how well in and tight this is. I've drilled out the centre and the 'stainless steel' outer will still not come out despite a...
  8. J

    P38A ABS sensor removal

    Tried that. guess what? yep. you guessed right :-(
  9. J

    P38A ABS sensor removal

    'should prise out' Hmmmmm I wish. I've had a spanner underneath the shoulder. Won't come out. I've had a spanner underneath the shoulder and tapped it with a hammer. Guess what? won't come out. I've drilled. hammered it, wd40'd it for 2 days and guess what? yay! you guessed it won't come...
  10. J

    P38A ABS sensor removal

    apologies guys, this is my first post but does it not say P38 in the title? Dave
  11. J

    P38A ABS sensor removal

    Hi Everyone. Read lots on here and been great. I'm now losing the will to live over..... yes, an ABS sensor. Cannot get it out. Lots of wd40. already destroyed the centre by drilling it but it will not come out. Any help or suggestions would be welcome. Pleeeeaaaase :-(
Back
Top