Search results

good morning all you wonderful persons I have a a P38 range rover 4lt V8 petrol 2000 year model auto gear box The righthand head gasket failed about 3 weeks ago so stripped it down and did both head gaskets. All of the faces looked good and flat after cleaning, put new valves all round in...

I would if I could but I don t know how sorry I have spent the last 5 years stripping it down to the bare chassis welding the chassis in 2 or 3 holes it was not bad a condition other than having to remanufact a new rear cross member

I think the green ones are for the rods the one I have purchased is white keep fingers crossed thank you for pointing it out will let you know how I get on

Thanks for your help I went out and tried it again and the blessed door opened so was able to take the door card of. From there it got a bit complicated, got in touch with my supplier and was told that I needed to buy the inner door handle £80. Went on line and found the land rover part No...

It must my age but I am sorry I don t understand the wit I did really think the site was to pass on help but to help one another now days it not COOL i assume that s the trouble with being an old fart

this is the first sensible reply. Hope to fix with part No FVF10002L waiting for it to come It good to hear from you thanks for jour conser

thanks for all your very funny comment I have now sorted it out

hello fellow range rover owners I have a problem with the o/s door lock on my dear range rover P 38 4 lt v 8 petrol Problem is I went to open drivers door from inside and the handle went clonk it lost its spring leaving it in the pulled out position I open the window to open it with the...

I have had a lot of parts for britpart and been very satisfied with except for the maff sensors as I mentioned earlier which I must say they did reimburse with no trouble my supplier did it all for me

I must say I have had good value from britpart

I do hope I have not done the wrong thing I better sell it after I have done them

Tell me where they britpart

I think I shall have to put a new axle on as I believe this is the third one’s,you can only put 3 sets in

I have put britpart one’s in just hope that they are better than the 3maff sensors I had on warranty thank goodness

Are you replacing the top and bottom ball joints I have just done the offside ones on my motor got to do the near side this week what a job best of luck

Key is ok not not worn It turns from lock to unlock and moves the inside slider about halfway which is not what it’s supposed to do it should go right across

The nut you are talking about is the adjustment collet put a balljoint splitter in the gap on the top and bottom balljoint but you must take the hub out first if as I understand that you are going to fit new swivels

Hello everybody it has been a long time since being on line I have been rebuilding a two door range rover over several years I have it on the road now but I Have a problem with the left hand door lock I cannot get it to unlock from inside & outside with the key. Can anybody help me with this...

I would get it checked out but it may be alright to drive you must have it seen to before MOT