Search results

Has anyone fitted the driving lights? I've got a brand new set to fit (along with an A Bar) and haven't got around to fitting either yet. Much of a job?

I've got some hex head self tappers to go through and hold it together. Just need the weather now.....

Out of curiosity, my facelift has the 5 spoke 16" Freedom wheels which I've seen on both the facelifts and the pre-facelifts. Does that mean there is two versions of this wheel?

Thank you. Looks good.

Diesel Do, I don't suppose you have any pictures do you?

Ah, I guess some of the plastic welds have gone a bit skyward. I wonder whether it's worth taking the whole bumper off to fix it or just to put a couple of self tappers through it to hold it in place if it gets too loose.

Not fogs, have got those. The driving light kit comes with its own loom (I have one in a box waiting to be fitted). I've checked all the wiring diagrams I can find and can see the colours anywhere! Maybe it's for the flux capacitor!

Anyone got any thoughts on the little connector?

The bottom section of my front bumper (the grey bit in the middle, under the numberplate) looks as though it wants to remove itself from the main front bumper of my Series 1 Facelift. Is it supposed to come off separately or is the whole bumper one piece? I'm just wondering what the best way...

Confirms why mine isn't plugged in. Thank you.

Indeed that would have been helpful! It's a 2006 TD4. Here's pictures: Thanks.

Nope, that's connected the 3 pin connector with the Pink/White stripe cable on the drivers side of the engine bay! :)

I'm wondering is someone can help me out with some of the wiring in my engine bay? I've just noticed a couple of unused connectors attached to the wiring loom near to the battery/fuse box One is just to the right of the battery, with a black connector which looks as though it connects to a...

Thanks, I'm looking for the clips for the front foot well.

Can anyone post a picture of the correct floor mat clips I need for a FL1? There are a few different types about so I just wanna make sure I order the right ones. Thanks.

Yeah, they help a little, but I think ideally the window needs to raise another couple of mm (it's been re-calibrated) or the frame of the soft top rear window needs to be a couple of mm lower. I've read that the corner locking posts can be adjusted, but haven't looked into that yet...

Thanks Skinny Mike. Our's goes up about the same.

Does your rear door glass go all the way up to the top of the channel which runs along the top of the soft top? Mine stops a few mm short of going all the way up and, as such, is very close to not being under the material of the roof all the way round. I've tried re-calibrating, but the rear...

I struggled to find a local locksmith who could do the Series 1 key and keyfob. In the end I found a mobile auto locksmith who could do it, it still wasn't cheap, but cheaper than a LR dealer.

I've found a couple of soft tops since I've been looking but they've been miles away. You're right about the shelf. Plywood and covering I think.