Search results

Hi, Just to update this thread, problem has returned and thanks to diagnosis by diesel fitter, new injector fitted and hey presto..... all fixed. But, thanks to all for help with this issue. Jeff

HI All, Had fault codes read, and there weren't any! But the warmer weather ie above 5° C and no problem with tick over! So think it could be related to FBH. Now its running ok will wait and see. Really do appreciate the time taken by you guys to help. Cheers Jeff

Thanks disco mikey, if this is almost always clicking, does it need replacing. Seems if its clicking the tickover is slightly uneven, but if its not the tickover is fine. I get a lot of grey/white smoke on start up too. I was thinking its the cold weather, cos it seems a bit better on warmer...

Can anyone tell me what the part is in front of the pump and filter, and to the left of the sedimentator. I thought this was a relay and its this that clicks. Cheers jeff

Hi, Thanks for suggestions, meant to mention that fuel pump relay in wheelarch is still clicking, even after fitting new pump & filter, Does this relay click all the tilme anyway?Can you tell me what TBH means? Is there some way of establishing if the fuel rail pressure sensor and overlay...

Hi Darmain & Vic, Fitted new filter and pump today, and sadly no improvement. Disconnected each injector in turn and the rough idle got a loss worse every time, so I am fairly sure its not an injector prob. Any other ideas anyone???

Hi Disco Mikey, Thanks for the offer, but I bought one and a filter, and its fiited, sadly it hasnt cured my problem either! Jeff

Thanks Vic, had a close look todayn, and the relays constantly clicking, have ordered a new pump and filter, shes done 125000 miles and well i guess its ready. Will let you know how i go on. Thanks again to you and Darmain for you help. Jeff

Hi Darmain, Guess thats costly, but kniowing the fault is going to help. The low pressure pump is it under the rear seat. I have seen a round shape their with three screws, always presumed this was fuel pump. Jeff

Hi, Tried the engine forum, but unsure where I should list this. I have a problem with my 53 TD4, its started to run rough on tickover, almost as if its running on 3 cylinders. Also noticed today that there's a ticking/clicking noise at the rear offside wheelarch area..... fuel pump? Tried fuel...

Hi All, having a problem with my 53 reg TD4. Its running rough on tickover although not bad enough to stall. It seems to happen only in cold weather, and dispite getting up to operating temp the problem continues. tried fuel cleaners and additives to no avail. Noticed a continuos clicking at...

Thanks for that "TheVengefulElephant" (there must be a story to that!) But would be grateful if you could tell me if the bite point at the top of the clutch pedal travel is normal? Jeff

Hi Folks, Need some advice. My 2004 TD4 Sport's clutch engages only at the very top of it's travel, when you've almost released the pedal. If it's a hill start there is juddering everytime. This week I put it into third instead of first to pull away from a slightly hilly junction (by mistake!)...

Hi Willo & Iain, Went to main stealer today, diagnostics revealed low diesel level in tank? Its not been below half for ages, anyhow no other fault detected. Now reset and it's been fine, SO FAR!!!! Still can't believe a low fuel level code would immobilize the engine!! Cheers Jeff:)

Tried above today, still showing Engine Malfunction. So probably off to main stealer on Monday. Its only money aint it! Thanks for help folks.Jeff:(

HI Iain, thanks will check that out in the morning, grateful for the ideas! jeff:confused:

Hi Willo, thanks for help, is cam sensorcalled Camshaft position sensor in manual, also is it something you can service or does it need straight replacement. Ta Jeff:confused:

HI all, well my day was good till me freelander decided it wasn't going to start. First off it started perfect and i did a short trip and back. I cleaned the car, then got in to move it and the engine turned but will not fire up. Engine Malfunction light is on it flickers after a few seconds...

Hi, Thanks loatmead & wigleytuff, your comments have really helped. the jobs done. ta very much

I read on here about cutting a hole in the undertray. Got to say it's made oil changes easy. Good luck