Search results

I seem to average around 33 mpg, but I have gotten around 38 with a gentle foot. Mostly motorway miles mind. Freelander (Land Rover Freelander) | Fuelly

Unless I've misunderstood the question, they won't fit regardless of size as the FL2 has a completely different bolt pattern to the FL1?

Same, Halfords Ultimate. As for the side lights, again Halfords own. They where either the Ultra Blue or the Laser Blue, I forget which. The colour difference didn't seem all that different during the day. Haven't had chance to check them out at night yet.

Oil and filter change. Also swapped all front lamps. Swapped front indicators to chromed bulbs, to get rid of that horrible fried egg look. Brighter H4's and some whiter brighter side lights.

Pending also.

No lift, not the clearest picture either, but 15" Jeep Grizzly alloys, with 225/75 R15 Colway C-Trax AT.

Pictures are showing up just fine! Any chance of a few different angles of it fitted to the car?

There are a further three screws holding it in, under the roof lining. Shown on step 15: Land Rover Workshop Manuals > Freelander Service Procedures > INTERIOR TRIM COMPONENTS > REPAIRS > Headlining - 3 door > Page 821

Bought and fitted these. 15" x 7" Grizzly alloys (from a brand I won't mention..) covered with 225/75 R15 Colway C-Trax AT. Fitted with plastic spigot rings, then an excellent fit. Need to buy some 55mm Land Rover centre caps for them now to finish the job.

Love the look of those!

I have the one's fitted into the window recess on mine, not had any problems with them. They sit nice and snug, do their job very well. I'm not a fan of the look of the stick on ones, I think they look a little out of place.

Painted my wheels black.

Fitted rear right ABS sensor and cleared 3 amigo's on the dash. Makes me a very happy lad haha! :D Now just to get my new keyfob encoded so I can get in the boot! I don't suppose anyone in the Manchester area has the software for doing my keyfob?

The glasses holder on the roof is the one bit I haven't done yet as I couldn't figure out how to get it out with pulling all the roof lining down! Undid the two visible screws, and took the oval clip bit from the middle, but didn't wanna budge. Anything I'm missing?

Spent a day doing some bits and pieces on the interior. I can't stand the teal (?) green colour of my interior plastics, couple of hours and a tin of black spray paint and we're looking much tidier. Sprayed the grab handles, door handle inserts and speaker grills. Sprayed up the air vents...

-

Cheers for the welcomes. It's well loved and will be looked after greatly, the missus isn't very happy because I'm spending more time with the car than her at the moment hah. I can well imagine! Should only be next month hopefully when I get the cash available to sort some new props and VCU for...

Wigan, nr Manchester.

Spent a few hours swapping the front ABS Sensors. Both sensors where stuck fast, so out with the drill and pliers. Once removing the old sensors, got the passengers side fitted nice and quickly. Then the drivers side.. Didn't at first realise I'd have to take the battery out.. and the...

Morning! How's it going? I'm Tom from Wigan. New to posting, but have been reading the forum for sometime. Just bought myself a Y reg 1.8 3dr Freelander. Have had a keen interest in Land Rovers since I was a lad, spotted this when I was in need of a car. Not too shonky for £500. Needed...