Search results

Hoover with a nozzle or a thin pipe taped to it .

Next time it will be faster

New sensor fitted and shes level at last.

It was still held in its position so was moving and giving consistent live readings. I think once under load it was deflecting a little and misreading.

I have got it out ok now. Bit of grease helped. I assumed the front left was dropping when all along the rear right was rising. I have not got another rear sensor here atm . Even tho both sides of the bracket were broken it was still wedged into position. I guess I have gone around the mulberry...

Well today my replacement relay arrived...swapped it over and....still the same.The only thing I have not checked is rear height sensors so I figured I would swap them over.... I am ashamed and embarrassed to say I think I found the fault ..the rear sensor is snapped off it bolts.

I have ordered a 2nd hand relay off ebay. When I went to pull my relay out the top came off it. Maybe its been apart in the past. I have not looked at the car since replacing the ecu Friday.

Yes 16 blocks

Crikey that relay is £100 from island 4x4. I have no leaks. The car rides on the lean.Right hand side higher than left hand side. When put in software it levels ok to all settings. When driven it leans. The steering wheel pulls left the transmission and gearchanges get noisy and the car rides...

What do you mean by standard relay...isnt the one fitted standard. I would rather put a proper one in. The breaker did not have any in stock. Guess thats my last attempt then ....before I order some springs

Ecu changed ...car still drives lopsided. The breakers mentioned that the ride height relay can cause issues so going to change that next. Does anyone have a part number ?

Hi , I totally agree with you about the ecu rarely being at fault but I feel I need to swap it just to rule it out. Chances are its original so 14 years old and 120k miles must take its toll. I would like to take you up on your offer if thats ok. I will pm you my address. Is the ecu you have the...

To clarify...not always going to designated height when instructed via software.The compressor is fine its gets the system up to pressure very quickly. I replaced both the valve block complete with solonoids and the driver pack and the fault remains identical. I am basically stuck now unless...

and if one has pauper spec non electric seats....? Eg me

I have checked that each corner does as asked which it does. Sometimes the car drives fine sometimes not its very random. I figured try a different ecu if only to rule it out. The thing is it doesnt always go to the preset heights even on command so I am guessing it could be an ecu issue...

Datatek . I have not done the +5check as yet but what I have done today is check both footwell side connections and clean. No obvious issues noted . I then decided to replace the valve block and driver . No difference she still has the lean. I drove to Cardiff this morning approx 20miles...

No overnight movement so leak free as thought

How is this function turned on and off? Mine does nothing when reverse is selected.

Hi Datatek I have packed everything away now so will do as you said tomorrow. I have spent all day rechecking and fettling...I set out new extremely precise floor levels and made up a new set of blocks and remeasured and adjusted every level again. I both measured and used spirit levels as...

I have the pc plugged in ...when I click go to a particular height it adjusts but not exactly as it should..eg as its set. For example on standard height the fronts are 113 and 105..but when i go to that height it sits at 111 and 107 respectively....Why ? Is this a clue. I always do the...