Search results

If can buy you a pint I will. Thanks thanks and thanks again!:rofl: I traced the green wire from flasher unit back through the loom and it was connected to the voltage stabiliser, which is why that was working until you turned on the indicators. One of my stupid errors in sorting out burnt...

Yes thats how they are With blue white to C Green & (purple/pink) to C2

Hella 4NM OU1 803-16 12V 21W/6W When I was getting bit together to rewire the landy, tried to get one of these and couldn't locate one

The phot of it was taken prior to it being stripped out, you can still see some burnt wires init. None of the wiring effected this! Ie replaced.

Connection on it C2 green @ purple/pink 49a brown@green 49+ green C white @blue Checked all points no power source going to it! Or out of it!

Checked all connections into flasher unit, no power going to it! When indicating left or right

No multimeter! Just been out and checked everything again all connections look good, but no indicators! But they intaially worked, then stopped after ii had fitted the voltage stabiliser. But looking at the wiring diagram I can't see how that would effect the indicators. Quite baffling

Wipers, lights, heater, brake lights all work. Landy starts and runs. The only thing not working now is indicators and fuel/temp gauges. Which both worked initially when I put the new volt stabiliser in until I connected the brown wire to the wrong place.

Is the indicators effected by the voltage stabiliser???

Thanks for this it made things seem easier, much better diagrams than the ones I looked at. Where did you get this wiring diagram???

Checked all connectors and earths, twice in case I had knocked something loose. But they all seem good. The bulbs all look good as well. Hopefully attaching the brown to the back of the ignition switch will sort it.

How did I miss that!!! Just looked on the back of ignition switch and found the connector, attached brown wire horn worked:rolleyes: Indicators still don't or the fuel/temp gauges, hopefully when I get a new volt regulator for back of clocks, it should be...

Horn doesn't work with it unattached, but does work with it attached despite the fact that the indicators don't work.:confused:

I've got a photo of the fuse box before i stripped everything out and it was not attached to it then. Just as shown in this photo

Sorry petrol Swb 1975

Hi all, After some help with a little brown annoying wire!!!! I've recently replaced the main wiring loom after a small electrical fire behind the clocks. I had all the wire out and replaced after cutting the connectors off on the old loom in place and replacing them with like for like colours...

Thanks all for your replies and ideas!! Have ordered new loom from autosparks today thought about making one, but decided on a ready made one colour coded with correct connectors etc. Mr Churchill I like the idea of clipping the ends in place to give you the hint/colour of wire you need. That...

Just been on autosparks, trying to work out which loom I need. Looks like it will be main and engine loom! Bt not sure wether to get the chassis loom as well!:cool:

Thanks for the welcomes and comments:)

Thanks Dipypud have thought about making one! But still trying to work out the cost of wire and connectors etc Plus I am still new to this game of looking after a 38 year old landy and my mechanical know as average